Search results

  1. joey nathan

    Cards for tilt/trim sensors

    Local marina assured me they would put in an order for more - just trying to get something a little sooner...
  2. joey nathan

    Cards for tilt/trim sensors

    Good Morning Reference Alpha 1 Gen 2 outdrive Trying to locate the little round card internal to the trim sensor, mine has all the copper worn off and otherwise works fine, local parts house is out... TY
  3. joey nathan

    3.0LX Carb Kit

    0K 174898 Engine - Can someone help me find correct carb rebuild kit? Thank You in advance...
  4. joey nathan

    '97 MCM 3.0 LX

    Swapped in new module and she started straight away. $40 from O'Reilly, same part at West Marine $115 EST ignition same as 1988 Chevy Astro Van Thanks again...
  5. joey nathan

    '97 MCM 3.0 LX

    TY alldodge, neither lead is shorted to ground and coil itself measures 952 ohms - does this mean amplifier has failed?
  6. joey nathan

    '97 MCM 3.0 LX

    Just started - yes, that's the distributor, I have some checking to do Engine Serial Number 0K 174898
  7. joey nathan

    '97 MCM 3.0 LX

    Good day all, No spark condition: coil ohms are 0.45 primary, 9,105 secondary Can I check output of ignition amplifier with voltmeter? If so, what should I be looking for?
  8. joey nathan

    1997 Quicksilver 3000 Remote Control Removal

    Hello All, Having issues with shifter, got the handle off, removed three screws, nuts from under nameplate, but can't seen to get unit off the side where it is mounted. Is the snap ring under the 11'16 nut my problem? My snap ring pliers don't quite have enough reach... BTW,the link to the...
  9. joey nathan

    What Is This?

    Hello All, In series with an interior light mounted to front of engine cover n wires mutilated by engine pulleys It's on a '95 Four Winns Horizon TY
  10. joey nathan

    95 Four Winns 5.0

    Hello All, Trouble is VDO temperature gauge laying on zero when running with new thermostat; and grounding the brown wire on the manifold causes gauge to deflect full scale. Is sending unit p/n 3853787 correct for this engine? (OMC 502 APHUE)...
  11. joey nathan

    2000 50 HP ELPTO Cooling bypass

    3 cylinder, 3 carburetor 2-stroke Intermittent warning buzzer; have eliminated oil reservoir as it is full. Strong stream from tell-tale of warm water. Pulled, inspected thermostat, temp sensor and nothing apparent. Is there a bypass water valve on this engine? Should I just replace 'stat...
  12. joey nathan

    1986 OMC 5.7 L Need service literature - SOLVED

    Carbureted engine 57 4APKW / Serial # T0908833 with Cobra Stern Drive - Specifically looking for canister fuel filter P/N Thanks...
  13. joey nathan

    Only Get Throttle When Shifting

    '97 Mercruiser 3.0LX Alpha-OneGen-Two Yesterday when I go to leave the dock moving shifter forward only revved engine and did not shift me into forward. Reverse seems to work okay as that's how i returned to the dock. What would cause that? Remote is Mercury 3000...
  14. joey nathan

    Love This Site

    Had 15A ignition fuse intermittently blowing last couple of days. Several posts on here pointed to a bare wire of some sort shorting either to another wire or on the engine block. Well, sure enough, there was a BLACK wire with frayed/melted end laying on top of the intake near the carburetor...
  15. joey nathan

    Anybody Have This Happen?

    Good Morning All, 2000 50 ELPTO - I understand a number of these voltage regulators/rectifiers have failed over the years. Rectifier was totally fried and we're probably lucky it didn't start engine on fire. So I replaced rectifier and a couple melted bullet connectors only to find that the...
  16. joey nathan

    How Many Amps?

    Good Morning, 2000 50ELPTO What is the output of the alternator? Is there a website for this info? Thanks All...
  17. joey nathan

    Water Pooling In Bottom Cowl

    Good Morning, 2000 50 HP 2-Stroke Shouldn't there be a drain somewhere down it there? Where is the drain hole that's plugged? I'm going to try a piece of coat hanger to clear it out? Bottom portion of the cowling level full with water...
  18. joey nathan

    Still Battling

    2001 Johnson 70HP 2-Cycle - J70 PLSIS Now it will start and run for a few seconds, then stall. New spark plugs and fuel primer solenoid. This after removing all three carbs; replacing the primer bulb, hose, and fuel filter; putting non-ethanol fuel in the tank; and finally replacing the VRO2...
  19. joey nathan

    Tried Everything - Still No Start

    Hello All, 2000 70HP Johnson J70PLSIS 2-Stroke 3 Cyl/3Carb Ran last September. Cranks over fine but no pop(good Optima Blue Top battery), will run for a few seconds on ether but no start. Here's what it isn't: I've replaced fuel line with pump bulb, spark plugs (NGK R BPZ 8 HS-10 @ 0.030&#148...
  20. joey nathan

    2000 Johnson 70HP No Start

    Hello All. Two cycle, three cylinder, three carburetor. Plugs look okay - pulled, gapped, and cleaned them. Seems like it's not getting fuel. Starting fluid will get it to run until it's used up. Question: what's the thingie on the side of the motor with a schrader air valve on it do? Looks like...
Top