Search results

  1. W

    OMC I/O water coming from around prop

    Ok I have been runnning 1988 Bay Liner in the yard on muffs,tuning ect. before entering water. Its a 3.0L OMC. I noticed water running out from between back of prop and the lower unit housing. prop spins free, does not seem to be any noise.Is this normal for water to be coming from that area...
  2. W

    Rotor for distribrutor 3.0Lomc ?

    Just wantd first to thank all you for your input on my past concerns. Ok next I did a tune up my 1988 capri 3.0 L. Went to Napa auto parts for the kit . Installed parts in kit(Points, rotor, condensor. Started motor, it skipped ran rough at hi RPMS Boat stalled on water would not start until I...
  3. W

    Proper engine temp. 3.0 L OMC

    I put a new thermostat in my 3.0L OMC. It is in a 1988 Bayliner bowrider. I thought the enigine Temp. was a little high so i changed the T-stat . But engine still Runs between 180 and may be 210 degrees. I can hold my hand on manifold towrds back and feel the thermostat open and shut just by...
  4. W

    A little water between mainfold and head 3.l omc

    Back Agian. Recent post was boat stalling after hard run and not starting until after waiting 20 mins. or so. I have changed all fuel filters and tuned up. Rebiult carb. Still seems like does not run smooth after it gets hot or runs hard. Mind you have not had in water agian since the problem...
  5. W

    3.0L OMC GM motor stalls when run high RPM

    I have a 3.0l omc inboard, it is in a 1988 capri B/R. The boat sat for the last five years but was winterized before setting. I bought it replaced coil , points and rotor. Added fuel with carb cleaner. Started up and ran pretty smooth in yard with muffs. Let it run to make sure no over heating...
Top