Search results

  1. C

    No Forward or Reverse

    Hello, Im trying to diagnose a prob. with my 92 Force 150 Ser # 027577 Mod. 1508X92C. May father had the boat on a trip to the lake and spun the prop. He consulted a boat shop and the sold him a new plastic hub and told him to tighten the prop nut while the shift lever was in in forward. He then...
  2. C

    Force 150 Piston

    I am replacing my number one piston on my 1992 Force 150. I noticed in a few other posts Frank had mentioned needing to use a "bearing kit" when going back in with a Wiseco piston. Is this bearing kit for the wrist pin end?. The guy who looked it up didnt mention it. If I do need this kit does...
  3. C

    Force 150 Head

    I broke a ring in number one piston on my Force 150 cylinder looks like it survived and should hone up ok. The head on the other hand looks terrible all pitted and dinged on the top. Does anyone know if this is even worth putting back together ? even if the cylinder does clean up how would it...
  4. C

    Force 150 Piston

    The number 1 Piston on my Force 150 is dead no compression. It was over revved after the throttle stuck wide open on the hose(long story). After taking the head off it is clear that it basically melted the piston, did not seize the engine. The other cylinders seem fine and tested ok on...
  5. C

    Force 150 No Spark

    I took my 1992 Force 150 to a guy who seems to know alot about these motors after syncing the carbs, adjusting the timing and a few other things he and I notice a strange hummm coming from an electrical module that seems to go to the spark plugs, he claims it is not normal. He said that he...
  6. C

    Force 150 Timing

    Im thinking I goofed and adjusted the timing tower on my 1992 Force 150. Then I happened to see that timing mark on it yikes, I havent started it to see how bad it is.. Can anyone tell me what the correct timing is for that motor..I will have to get a timing light im assuming that the plastic...
  7. C

    force 150 Idle Position

    My 1992 Force 150 doesnt return to idle. When I pull the throttle back to idle It doesnt go all the way back, the vertical rod with the screw stop never hits the stop. I can go back to the engine and push the cable whole aft and it returns to idle, its almost like the cable is missing a clamp or...
  8. C

    Prop Question

    I have a 1988 Stratos 19 ft. 189 F/S this boat has a 1991 force 150hp motor Model 1508X92C. The prop numbers on the motor are 48 817718 A40 17P The boat only runs 41 mph. and about 4800 RPM seems pretty slow for a light boat and 150 hp motor. I cant decode these numbers on the prop.. Does...
  9. C

    1991 Force 150 Trim Limit

    Does anyone know if the 1991 Force 150 has a trim limit switch ? and if so where it is located or how I can check it Coolbreeze135
  10. C

    1991 Force 150 Trim Limit

    I just bought an 87 Stratos 187 F/S, the previous owner installed a 1991 Force 150 on the boat. The tilt and trim works fine and does not seem to leak down at all. However when I went to the lake today for the first time I noticed that while at idle in gear the trim goes all the way up and...
Top