Search results

  1. M

    81 70hp Evinrude

    Could someone tell me if a Yamaha tacho will be compatible with my 70 hp Evinrude. The tacho came off my old '89 50hp 3 cyl Yamaha.<br /><br />cheers<br />mike
  2. M

    81 Evinrude 70hp

    Hello Everyone,<br /> <br />I have an Evinrude '81 70hp and when I crank the starter motor over, it starts to crank slow for maybe five seconds then picks up speed to a normal speed crank. I have pulled the s.motor apart and didn't find anything untoward, the brushes were "used" but not that...
  3. M

    84 Evinrude 35hp

    Hello All,<br /><br />I have an '84 Evinrude 35 which I have just finished rebuilding. I started it today for the first time and it sounds great. What a relief!! I have only put new rings and bearings in it, the pistons and bores were still good. Should I follow any particular run in...
  4. M

    84 evinrude 35hp fuel question

    Hello,<br /> <br />I have an '84 evinrude 35 E35ELCRR and I have a couple of questions. <br /> I am going over the carb again cause the engine is running a little rough. It has just been rebuilt, it appears there is way to much juice going into the engine. My manual says the float level...
  5. M

    '84 evinrude 35hp

    Hello All,<br /><br />I have just finished rebuilding my '84 model evinrude 35hp (E35ELCRR) and am ready to start it for the first time. I have since bought a replacement for this motor so the evinrude is going to be sold. <br /> The motor has plenty of spark and fuel, when I turn it over...
  6. M

    '81 70 hp evinrude

    2 things,<br />1 I have a 81 model 70 hp Evinrude. I pulled the carbs off to day to give them a clean, I found in the middle carb there is a jet screwed in the float bowl (not sure of the correct name for the jet). It appears that some one has had a go at removing the jet before and damaged...
  7. M

    carb float level

    I have an 81 model 70hp Evinrude out board. Can anyone tell me what the float level setting is for this motor??<br /><br />cheers <br />mike
Top