Search results

  1. D

    EVINRUDE TIMING/LINKAGE ?

    I swear I just posted this but I do not see it...<br /><br />anyway..<br /><br />I have 1978 85hp Evinrude...<br /><br />I cannot get the linkage set correct for the timing linkage/carblinkage...<br /><br />I have not idle I have good mid range and top end.<br /><br />The only way I can get it...
  2. D

    1978 85hp Evinrude?

    Took the boat out thought the carbs were dirty could not get full throttle out of it...<br /><br />So,,, I pulled off the carbs and they looked great. Still cleaned them out anyway. <br /><br />So whenI run the motor on the hose it runs great stick it in the water cannot get it to start....<br...
  3. D

    20hp MErc PROBLEM(S)>>>???

    This motor had not spark to start off with the owner told us the flywheel dropped the magnet out of it. So it ruined the pick-up coil. replaced it and starts up fine but runs very high.... Throttle is closed. If I spray down around the base of the motor it slows down. <br />Could the base...
  4. D

    20hp mercury parts needed..

    Need...<br /><br />Flywheel<br />pickups<br />& Stator...<br /><br />Thanks...
  5. D

    Year and parts for 20hp merc.

    Friend of mine just bought a 20hp mercury...<br />Ser# 5409543<br /><br />Something came loose under the flywheel and destroyed everything under it and the flywheel.<br /><br />So to make a long story short I am looking for a flywheel and all of the electrical under it..<br />(charging system /...
  6. D

    TCW-3

    I read somewhere that TCW-3 is Two Cycle Water Cooled... What is the 3 for?<br /><br />Thanks
  7. D

    Tilt/Trim?

    I have a 1978 85hp Evinrude...<br /><br />The tilt trim does go up and down but if I go to trim up the pump runs and takes about 3 seconds or so before it starts to pump. On the down stroke it pulls the 2 smaller pistons in first then the center will go down and fall to the transom. ONce it is...
  8. D

    Sealing lower unit

    I have a 1978 evinrude 85hp..<br /><br />Do I just need to remove the bearing holder and replace the 2 outter seals and the oring?<br /><br />Thanks
  9. D

    Old Evinrude Parts...

    I am looking for some old parts for my controls for my boat. Seems that the parts are no longer made... I have the part numbers.<br /><br />Does anybody know of a dealer that has old parts on their shelves?<br /><br />1978 85hp Evinrude.<br /><br />Thanks
Top