Search results

  1. J

    crack on thermostat cover - leaking water from the crack

    New cover or use marine tex? Crack about 3cm long
  2. J

    1994 25 hp Merc water leak

    Re: 1994 25 hp Merc water leak Hey Phill, did you have any other problems? and was the water flowing out like the photo? right now I have that issue after I changed my water pump. 0
  3. J

    Normal for water to flowing out thing this

    1994 Mercury 90hp I just changed my water pump and noticed the water flowing out through this hole in the picture. I never seen it like that, and is it normal?
  4. J

    Wiring front bow light

    I have a 1994 Sea Pro 17ft v-hull and I Want to replace the front bow light. I can't seem to locate the old wires. Any tips on how to get the new wires from the front to the center console?
  5. J

    thinking about adding Solas Titan prop

    I have a 1994 Mercury 90HP two stroke outboard on a 17ft seapro v-hull fiberglass and I might add a Solas Titan Propeller 3X13 1/4X19R Stainless Steel. Do anyone have experiences with Solas brand props? Should I got with the 19 pitch or go lower or higher?
  6. J

    1994 Mercury 90hp two-stroke - stalls bad

    1994 Mercury 90hp two-stroke All last year my motor could not pass 3500 rpm. Every time I try to WOT pass 3500 rpm it would just stall. Before I took my boat out this spring I changed the following: - Spark plugs and wires - Change gear lube - New fuel water separator - Fuel filter When I...
  7. J

    Looking to buy a new prop

    Mercury 1994 90 HP Outboard 17ft Sea-Pro CC - usually fish with four guys Saltwater fishing I removed the old prop but could not find any kind of numbers to tell what size or pitch I need to replace with. Can anyone suggest me the right prop I need to buy. What would be best three or four blade.
  8. J

    Trouble starting & WOT

    1994 Mercury 90hp 3CYL - Saltwater fishing Having trouble starting my motor and WOT. I alway have to give my motor gas before I can start. I don't think its good for me to always put the throttle in the forward position to start my motor. Also I can only get up to 3000-3500 RPM and max speed...
  9. J

    Need Advice!! 1994 Mercury 90HP

    I broke one of my bolts attach to the motor case. As you can see in the photo now there's a hole with the broken end of the bolt still in there. The reason why I tried to remove this bolt in the first place was to clean off some corrosion off the ground wires connected to the bolt. First...
  10. J

    Trailer Repair - Bracket Rusted

    My brackets that are supporting the wood bunks have finally come to an end. I would appreciate any suggest on how to repair or replace those bracket. Keep in mind those brackets are rusted to the core. Boat size: 17cc seapro fiberglass 90hp engine
  11. J

    1994 Mercury 90hp - Burnt Wires

    I need some info on the circle wires. I want to know if I can just replace those single wires or the whole wiring unit.
  12. J

    Hesitation on acceleration

    1994 Mercury 90hp 3cycle Problem: hesitation on acceleration - starting is moderate; sometimes I gotta put the throttle in gear to start and kick back the throttle to neutral. Idle runs fine; but when I throttle pass 4000 rpm it starts to hesitating. So as long as I throttle down below 4000 rpm...
  13. J

    Switch board problem

    Boat Setup: I have a 17ft boat. Two battery setup hook up to a two battery switch. Main battery and switch located towards the back of the boat. Secondary battery located inside the console. I have 8 gauge power wire runningn from my battery switch to the secondary. 4 gauge for my main battery...
  14. J

    VHF Radio Installing Suggestion

    I have a 17ft cc and I want to install a VHF Radio. But do to space on my cc, I'm thinking about installing it on the cc door hatch. It's close to my circuit broad and its hidden from saltwater splash or spray. Any suggestions????
  15. J

    Outboard running very loud and water pumping faster than usual...need help!!!

    I have 1994 Mercury 90HP, mainly used in saltwater. 2 weeks ago head back in felt like my engine was going to die at full throttle. So, I had to down throttle to stay under 2000 rpm. Another day, turn the outboard on land motor sounded louder than it ever sounded before and water pumping faster...
Top