Search results

  1. T

    1999 Evinrude ficht 150

    Had the boat out this week for first time in 6mos. (but started every 2 wks. or so) and the overheat buzzer went off and i shut it off instantly. Waited about 10 min. and fired up with no problems and buzzer never went off again. Didnt make any long runs but enough running for it to get hot...
  2. T

    Fuel or timing issue?

    Got an 1982 evinrude 70 that died 7wks. ago no spark. Replaced the timer base with a used one same #s and fired right up. Took it out for first time today and started right up started to take off and couldnt get over 1800-2000rpm to plane out didnt die just no power. Question does timing need to...
  3. T

    Fuel pressure question

    Is 18-20psi enough pressure on a 99 evinrude 150 ficht?
  4. T

    150 ficht no start

    Got a 99 evinrude ficht that died on me yesterday while on the water. Started losing power like bogging down but idled fine then the check engine buzzer went off and died. Still cranked easy and sounded like compression was good and even tried startin a couple times. After getting back and...
  5. T

    Replacing cables

    Going to replace shift and throttle cables on a 99 evinrude 150 ficht are there any special adjustments or just get them back in the same place they are now since they weren't broken? Thanks!
  6. T

    Evinrude shifting problem

    Got a 99 evinrude 150 ficht with omc controls and lately when i'm running and slow down to put it in neutral it stays in fwd. unless i pull the control arm just a hair back past the neutral position then it ungages. Reverse works and shifts normal feels like there is a little more roughness and...
  7. T

    Steering cables

    What is the correct way to measure steering cables if there are no markings on the cables. Thanks!
  8. T

    Steering systems

    Got a little 14 foot shallow water scooter that has a lot pulling to the right and adj. the tab has not really helped and want to get a rotary no feedback system for it. It has a old rotary on it now but can't tell if it is no feedback or just a standard system, what kind of system would you all...
  9. T

    Evinrude overcharging

    I've got an 82 evin. 70hp. that is over charging 17.o volts thought the gauge might be off but verified with a digital volt meter. Any common problems or things to check anyone can suggest. Thanks!
Top