Search results

  1. W

    Merc A1 Alignment info PLZ!!

    Ahoy, (this is on a "88" 5.0 Merc Alfa1) OK I now have my alignment tool and the drive off. I basicly understand the process, However after reading many forums about this (which I've never done) no one has addressed the raising and lowering the engine process. With all the money I have...
  2. W

    1988 Celebrity 195v Fuel Gauge

    Hi all, I have an issue, OK my sender has power and sends a signal to dash so I Assume that the gauge is inop. (needle at dead South no matter what even a direct bypass) So I need a new gauge, Now doing a searh here comes a bit short, do to the special mounting for Celebriy/Champion boat...
  3. W

    1988 195v Fuel Gauge

    Hi all, I have an issue, OK my sender has power and sends a signal to dash so I Assume that the gauge is inop. (needle at dead South no matter what even a direct bypass) So I need a new gauge, Now doing a searh here comes a bit short, do to the special mounting for Celebriy/Champion boat...
  4. W

    Vibration from I/O (not sure from where)

    Hi all, OK after replacing: I/O Alfa one (all brand new including u-joints), lower shift cable, all the bellows, G-bearing. Greasing all zerk fittings on gimbal housing (with marine grade) and a rough shift cable adjustment, I took her out for a test run. Results: (Note, I am following...
  5. W

    New Stern Drive Break-in Period advice

    Hi again everyone, OK she?s all back together. New Stern Drive, gimbal bearing, all 3 bellows, all new seals (gaskets and O-rings), Marine gear lube and lower shift cable. Now for the break-in time. The material shipped with says to: Start w/low rpm's slowly increasing in rpms up to 3500@5...
  6. W

    Alfa1 I/O Bellows, S-cable, G-Bearing and Gaskets

    Hi everyone, I finally have all the parts for this project (I hope). My lower half has been returned (warranty for no reverse). So instead of slapping it back on and taking her out. I decided to take it to the next lvl of maintanace. So I purchased the kit w/new shifter cable, Gimbal bearing...
  7. W

    Engine interrupter switch "88" a/1 i/o

    Hi everyone . I have a 88 merc alfa 1. I was told that the reason I had to replace my broken I/O was do to a bad control cable. OK, so I bought a new I/O , new bellows set is also being replace while I have it apart. My question is what control cable is making the interrupter switch not work...
  8. W

    "88" A1 Merc, I/O no reverse??

    Hi, ( I did read a few posts before this, but not same problems, me thinks). I have a 88 Alfa1 i/o. Replaced the complete drive with a NEW SE 106 upper and lower. Put it together with the great info here and with the instructions had everything lined up correctly and in forward, as per the...
Top