Search results

  1. C

    1991 Force 120 temp sensor.

    I called around and bought a new sensor. The problem is I can't seem to locate it on the engine. I'm pretty sure it has one, I just don't know where it is.
  2. C

    Steering problem i've not yet heard about.

    I have had stiff steering for a while now. This weekend I finally bought a new rotary system and cable. I began to put it on and I realized that the problem wasn't my steering cable or the pivot shaft on the motor. It turned out that the hole where the cable exits the transom and goes into the...
  3. C

    '91 Force 120 overheating issue

    I changed my impellor around 7 months ago, so it's probably not the issue. Plus water comes out of the water exhaust when running. But yesterday I was running at W.O.T. and after about 10 minutes the temp gauge shot up all the way. I got to a idle zone and it shortly went all the way back down...
  4. C

    1991 Force 120 tilt/trim

    I have a 20'Bayliner with a 1991 Force 120. The tilt cylinders slowly creep down. I've tried everything I know to fix. I began to remove them to rebuild. After I disconnected all of the hyd. lines, removed the nuts on the end of the bolts that run horizontally through the cylinders and the motor...
  5. C

    1991 Force 120 prop question

    Where can I find a 4-blade, 17 or 19 pitch prop in either stainless or aluminum?<br /><br />Question #2: How hard is it to rebuild the tilt-trim cylinders? And is it worth repairing or just replace?<br /><br />Thanks in advance.
  6. C

    1991 Force 120 tilt/trim issue

    Over the last three years i've had to take the trim motor apart and clean the brushes and the armiture and it will work fine. This last time it didn't do the trick. I checked the brushes with my ohm meter. It had continuity. The armiture spins freely when in the pump, so it's not binding up. Is...
  7. C

    1991 Force 120

    Here's what happened. Went out Saturday and boat was running fine. Started right up and everything. However,after running for about an hour it was not wanting to start. After starting up it would only run about 10mph at about 2000rpms. Plugs are brand new,carbs are extremely clean. I believe it...
  8. C

    1991 Force 120

    I have a 1991 Force 120 on a 20' Bayliner & when I throw it all the way in reverse, the motor pulls itself out of the water. Idling is fine. Is there possibly not enough fluid in the pump or could the seals be going bad in the cylinders?
  9. C

    1991 Force 120 lower unit

    I pulled my lower unit off to change the impeller & gaskets. Took no time at all. Until I tried to put the lower unit back on. I can't get the drive shaft, the shifting rod & and the top of the water pump to all line up. I got a little frustrated and tried to force it and broke the water pump...
Top