Search results

  1. F

    1964 johnson 5.5

    anyone know were to get the rubber seal around the pull starter its the one on the cowl thanks
  2. F

    1964 5.5 johnson

    is this motor 24.1 0r 50.1 just want to make sure
  3. F

    plug wires

    i changed my coils,plug wires and put a tune up kit on and dont remember which plug wire goes were any one know which coil is for the top sprak plug thanks
  4. F

    oil seal

    which is the top and which is the bottom on one side i can see the small spring around the rubber
  5. F

    5.5 pinion gear (shock absorber)

    anyone know were to get a good used one or know anyone that will part with one thanks
  6. F

    johnson 5.5 lower unit

    i have a 64 5.5 i changed all seals and o rings new impeller when i put it back together it shifts in to f n r fine in netural the pro spins nice and easy in f-r the prop is tough to spin by hand im spinnig it clock wise any ideas
  7. F

    64 johnson 5.5

    i have a dowel in the lower unit castings in the front it seems to be pushed all the way in any idea how to remove this and get a new one its in the gear case
  8. F

    where to get paint

    anyone know where to get paint and primer for the old outboards besides nymarine
  9. F

    johnson 5.5

    does it matter which way the oil seal goes in the bearing housing thanks
  10. F

    cd-21a couple ?s

    i've searched on the site and cant seem to find what im looking for i want to reseal my lower unit i have a few questions #1 when putting a new seal in the gear case head do u just put the new one in or do u have to grease it or anything #2when putting the gearcase cover back on i have a long...
  11. F

    5.5 bearing housing

    anyone know were to get a used bearing housing for a 1964 5.5 cd-21 thanks frank
  12. F

    cd-21a

    i got a 1964 johnson 5.5 took of the lower unit and there is no gasket anyone know were to get or what to use to make one i also need the rubber one for the gear case any help will be great thanks
  13. F

    johnson 5.5

    can u do a compression test with the lower unit off sounds like a stupid question but want to make sure
  14. F

    64 johnson 5.5 help

    i got this motor in pieces and finally got it together but its is hard to pull start, the motor isnt locked up any ideas what it can be thanks for your time
  15. F

    1964 cd-21 shaft help

    hi i got a johnson 5.5 for free in pieces told it ran when it was took apart my question is i know were everything goes but the stuff on top of driveshaft i have a brass colored washer a maybe 2 inch spring and a broken piece of round black plastic is this all that is supose to be there so i can...
  16. F

    evinrude lower unit

    hi i have a 1975 #4506 evinrude 4hp weedless it has a 2 blade im lookin to change the lower unit so i can use a 3 blade prop i found one its a 1979 Evinrude 4 HP Outboard Model# 4932. will this bolt up thanks for the help
  17. F

    1957 qd-18

    im having problems with the shift lever i took the lower unit off to inspect the impeller and had a bit of a problem getting the lower unit back on when i finally got it back on i noticed it will not go into reverse it worked fine before i messed with it any ideas i ordered a manuel dont know...
  18. F

    timing

    hi i have a 1975 4506a evinrude 4hp im goin to change the coils points and condensers i found that info in the faq section my question is will i have to put it in time when im done thanks for your time
Top