Search results

  1. B

    Anybody have a relatively new Allison Bass boat, wondering about the ride

    I'm thinking about a new boat, can't afford a real fancy ( expensive ) one, but I'd like to know if someone has an Allison ( maybe mod. XB21 ), or any of them for that matter. I know they are fast, but I want to know about the ride in rough water ( 2ft or better ).
  2. B

    Low end ship on a 1994 150hp 2 stroke evinrude

    I've got a low end ( idle to 2500 rpm ) skip on my 1994 150hp evinrude intruder. I have taken the carbs. ( 6 ), and put a kit in them, there was no trash in 4 of them, very little in the bottom two. I tried to clean all passage ways using 2o psi. air press.. It is hard to clean the passage way...
  3. B

    Identifying which carb has an idle problem on a 1994 Evinrude Intruder 150 HP

    Hello everyone. I've got a 1994 Evinrude Intruder 150 HP, that I recently epoxied the carbs. for leaking. I didn't remove the main jet plug and drain the carbs., I pinched the fuel line and ran it out of gas.......shouldn't have done that. I now have a carb. that has an idle skip, it clears up...
  4. B

    Need to know what prop should be on this boat

    A friend of mine just bought a 1980? 16 ft. Skeeter bass boat w/1972? 115 Johnson on it, does not have power tilt and trim ( needs it ). It takes it forever to come out of the hole, it won't get above 3600 rpm's. when trying to come out of the hole until it (finally) starts to plane off, don't...
  5. B

    Speeding up the trim

    Does anyone know if there is a way to speed up the cycle time on a 1994 Evinrude Intruder? Alls seals are fine, just need to know if I can make it faster.
Top