Search results

  1. F

    Redundant Fuses on Sonar Power Lead

    Hello, I am in the process of installing Structure Scan on my Lund Tyee. The dealer installed the HDS module before the sale. When I was under the console, I noticed that they used the inline 3 amp fuse and then ran that to the fuse block behind a 5 amp fuse. This seems redundant. To...
  2. F

    On/Off Illuminated Rocker Switch with 3 posts

    Hello, I am in the process of installing a Structure Scan module. The installation guide mentions using a switch to turn the module off when not needed. Apparently it pulls quite a load. I purchased an Ancor illuminated single pole single throw rocker switch, but it has three posts on the...
  3. F

    Lund Bow Sonar Power

    I am considering installing a bow sonar. There is already power cables ran to the bow. I was wondering how best to route the power up to the unit. On the dash, the cords run up behind the unit through a rubber seal. Not sure what this seal is called. What is recommended for the bow? I...
  4. F

    2011 Tyee 1750 Onboard Charger Install

    Hello, A few months ago, I bought a 2011 1750 Tyee with a 24V bowmount. I need to install an onboard charger and I am considering a 25 AMP Marinco Battery Charger 2623 Marine. Is this a good choice? Also, where on the boat would be best to install this charger? Thank you, Filovirus
Top