Search results

  1. J

    Look at these gearcase pictures!!! Seal Question

    Re: Look at these gearcase pictures!!! Seal Question Then there are two O rings inside the shift rod cover
  2. J

    Look at these gearcase pictures!!! Seal Question

    Re: Look at these gearcase pictures!!! Seal Question Here are some picture of the job. This does not include all of the steps but should help with some of the hangups or areas for mistakes. Step 1: Make stand (critical - I couldnt imagine doing this off the floor, i made one out of a piece...
  3. J

    Look at these gearcase pictures!!! Seal Question

    I noticed a small amout of milkyness in my lower unit oil today. Dropped the lower unit and removed the water pump. This seal seems to have a bit too much play in it. I have about 1/16 of an inch as you can see from one picture to the next. Is this normal for this seal?
  4. J

    Evinrude 150 Carburator Adjustment - Help?

    Just rebuilt the carbs on my (E150GLECD) 1998, 150hp. It runs much better, but could use some adjustment. Just wondering if there were any tricks to setting the idle jets. The manual says set them at 5 turns out and then to lean it out (1/8 turn at a time) till it begins to sneeze then richen...
  5. J

    Evinrude 150 Intruder (E150GLECD) Rebuild???

    The question that I have is should I rebuild my powerhead, or just keep running it? Here is the story below: At the end of last season were were at the lake as usual, wife was skiing and engine seemed to have just a little less power but I didnt think much of it at the time. Finished skiing...
Top