Search results

  1. 1960 Starflite

    Outdrive will not go back into transom

    Sure be nice if my driveway wasn't #57 gravel 😔
  2. 1960 Starflite

    Anodes for Yamaha outboard...Zinc or Aluminum?

    I'm in fresh water. My lower units on IO and OB had really bad pitting/deterioration . The aluminum anodes showed No deterioration. I switched to magnesium anodes, now I have no deterioration on outdrives.
  3. 1960 Starflite

    Going straight at low speed?

    My Century 190 is bad with wandering. 4 blade prop with trim down (if possible) helps but still there. Agree with small movements of wheel.
  4. 1960 Starflite

    old mercury

    I've a 1960 (300), 1965 (650) and 1975 (850). All have been good engines. The 300 and 650 have a magnito, which points are hard to find and expensive. The 850 has a distributor and switch box. Again expensive ignition parts if you can find them. Carburator parts (floats, gaskets, needle n seats)...
  5. 1960 Starflite

    Rebuild old mechanical Fuel pump or go for Electric Fuel pump

    I bought an electric fuel pump from eBay to move old fuel from my 30 gallon tank into 5 gallon can. Nope, never did work. Had to do the siphon thing, damn it tasted terrible. Three beers to rince my mouth.
  6. 1960 Starflite

    Grease Zerk Fitting Question . . .

    I'm 77 and learned something today😱
  7. 1960 Starflite

    Grease Zerk Fitting Question . . .

    My 1948 Pontiac has 36 grease fittings and 6 needle fitting points. Offen thought of going to an Jiffy Lube (if they still exist) for a lube job and have the attendant count the fittings. Then send him back under if short.😊
  8. 1960 Starflite

    Mercury thunderbolt 500

    Is that shaft worn under size at impeller location or a visual thing?
  9. 1960 Starflite

    9 amp to 16 amp stator overcharging

    Yes, there are many vendors for that type. I don't remember the part # but I ordered from Amazon
  10. 1960 Starflite

    9 amp to 16 amp stator overcharging

    I kept boiling the battery with my 1975 850 Merc. Voltage gauge was running at 17 anywhere above half throttle. Installed a 6 wire regulator, voltage now steady at 14.5v. You'll have to get creative with mounting.
  11. 1960 Starflite

    1974 50hp Mercury

    I purchased an old pontoon boat to get the trailer and 850 (1975) Mercury. It also wouldn't idle slowly by ear (I didn't have a Tach). I did a link n sink and found that previous owner had the timing belt advanced one tooth. Timing sets the idle speed.
  12. 1960 Starflite

    Distributor harness 1976 mercury 115

    A few years ago there was a detailed post with pictures showing how a member removed the filler/potting material, gaining access to solder posts for those wires. I should have saved the information but didn't. Might try searching the archives.
  13. 1960 Starflite

    Mercruiser 3.0 cranks but wont start

    Mine is a 1979 and uses glass tube fuses. Same symptoms, I checked Ignition fuse in place with ohm meter, OK. Checked while engaging starter, no voltage on engine side of fuse. Released starter and voltage returned to engine side of Ignition fuse. Pulled fuse, oxidized badly, cleaned, replaced...
  14. 1960 Starflite

    Mercruiser 3.0

    Being a 4 cylinder there should be room to get to starter lugs. To rule out starter, unhook both battery cables +. - Attached a good set of jumper cables neg to engine block positive to starter lug/bolt, attach pos jumper cable to pos battery post. Firmly touch neg jumper cable to neg battery...
  15. 1960 Starflite

    Pontoon I/O 140hp

    1st easy check, is there a rope wrapped around prop? My IO did and melted some of the rope into a disk between prop and lower unit, tearing the prop seal.
  16. 1960 Starflite

    Coupler failure

    Doesn't matter, Auto, Motorcycle, Boat. Deny is what they do !
  17. 1960 Starflite

    Hydraulic Steering for Sterndrive

    I too have that problem and with 1/2 the HP. 1979 Century 190 with 140hp four banger. Trimming up helps but then lose prop grip.
  18. 1960 Starflite

    Confused? Voltage Regulator vs Rectifier; Tach & Charging

    I had overcharging problems with my 850 Merc. It would climb to 17 volts at 4k rpm, boiled the battery. I replaced the rectifier with a 6 wire regulator. 14.5 volts at any speed above 2k rpm. It has a Tach wire too. I had to get creative with mounting.
  19. 1960 Starflite

    Decking Question

    3/4 inch Exterior ccx under vinyl is the way I went. Use 1/2" risers under railings is the key for water shedding. I also shimmed furniture and helm with ridged plastic. The old deck lasted 20 years under carpet and No risers.
  20. 1960 Starflite

    Tachometer for 1978 Mercury 500 Thunderbolt

    You'll need a tach driven by a signal from one of the yellow stator wires.
Top