Search results

  1. C

    Sea star steering

    I'm having difficulty bleeding my system out. I have a sea star, dramatic helm adjustable tilt and a sea star ram for steering the motor. I've gone through four quarts of oil trying to bleed this thing. I hooked the line from one bleeder to the other, crack them open and turn the wheel just as I...
  2. C

    Polarkraft hull

    We will also patch a plate to top and bottom with rivets for strength
  3. C

    Polarkraft hull

    Would love to but it's so nice I'm going to try and repair it instead not sure if welding will work maybe a rivited patch any ideas
  4. C

    Polarkraft hull

  5. C

    Polarkraft hull

    just purchased a 2012 2010wt polar kraft it has a 12inch crack in the hull any suggestions
  6. C

    115 evinrude vro

    I will check it thank you
  7. C

    115 evinrude vro

    Sorry it's a 115 evinrude crossflow gas just trickling out of pump runs 5min and quits I can keep it running by pumping tank bulb
  8. C

    115 evinrude vro

    Hi having trouble with new vro pump doesnt seem to be getting enough fuel to carbs is there a bleeder valve somewhere all hoses are new and zip tied
  9. C

    Ok corks go under thermostats everything working good no more alarm thank you !

    Ok corks go under thermostats everything working good no more alarm thank you !
  10. C

    Thermostats

    Thank you
  11. C

    Thermostats

    Ok thank you
  12. C

    Thermostats

    Other people I have talked to say they go under the thermostat
  13. C

    Thermostats

    According to the clymer book they show them on top of gasket around thermostat
  14. C

    Thermostats

    Evinrude 115 crossflow
  15. C

    Thermostats

    Where do the 2 cork gaskets go ?
  16. C

    90hp mercury

    how critical is it to run motor for 8hours before putting into service also nervous over oil injection i am running mixed and also injection for break in period should i keep doing this for awhile i installed a new crank gear ran all the air out its smokes alittle seems like it should smoke alot...
  17. C

    is it critical to

    is it critical to run rebuilt motor in a tank for 10 hours or can it be put into service after 2 and also two cylinders have about 125 the other 130 this is a 90hp merc is this normal
  18. C

    mercury 90hp rod specs

    i just purchased a 1989 19ft grumman open bow with a 90hp mercury blown i would like to know what the rod specs are i purhased a manual and it does not show specs for a 90hp also did i get a good deal i paid 800.00 for boat motor and trailer please help thanks
  19. C

    1984 johnson seized

    my motor quit all of a sudden and then wouldnt turn over with starter so i grabbed flywheel and it turns hard i also hear squeeking about mid section could something have set up in water pump? dont know where to start
  20. C

    1983 johnson

    need some input i took my boat out and ran it for 30min.it quit pulled the plugs first top 2 were coco brown other one was black so i changed them boat ran for 5 min. and quit so i took it to a marina to have compression checked 120 all 3cyl. they said the carbs were gummed up mind you i hadnt...
Top