Search results

  1. P

    Volvo SX-m Thrust Washer questions 2006

    My Buddy has a Monterey 2006 with Volvo SX-M outdrive 1.60 gear ratio I believe. 5.0 engine 2bbl carb. It has a michigan wheel prop. He bought a solas Prop. When we went to install it the Thrust washer from the old prop was way too small and doesnt fit the outer diameter of the new prop. Solas...
  2. P

    Alpha one Gen 2 SEI 116. upper 1.42 ratio possible failure

    I installed my upper and lower as a cobra conversion about 3 1/2 years ago. Ive been very happy with it. The oil was dark after the break-in I called SEI and they recommend a drive shower. I installed it. The oil still looked a bit dark to me each year it changed it. There was a little metal on...
  3. P

    Changing to non greasless Gimbal Bearing 1993 OMC Cobra

    Can I use one of the Permalube greasless Gimbal bearings Merc uses in my OMC cobra transom shield?
  4. P

    2006 Monterey 214 FS Ventilation unless trimmed almost all the way down

    I have a friend that bought a 2006 Monterey 214FS Wt 3400 pounds Has a 14 x 21 3 blade stainless prop. Apollo Brand I think.Volvo penta SX Drive. Chevy Small Block 5.0 liter with 2 bbl carb Volvo 5.0 GL.. I have a 1992 Sunbird 20ft with 5.7 OMC Cobra. My Trim gauge moves vertical, top to bottom...
  5. P

    King Cobra vs Cobra............... Identify?

    Can you tell the diff between a King and a regular Cobra? What is the physical difference. ?>Will a king Cobra Lower mount to a regular Cobra Upper? I Know the King Cobra is behind the Big blocks but how can you tell if it is no attached to a boat.?
  6. P

    Remote oil resevoir? 1992 OMC Cobra

    Can you add a remote res to an OMC Cobra outdrive?
  7. P

    Proper stern drive lubricant

    Is it OK to put just a good quality 90W gear oil like you put in a cars' rearend in an OMC Cobra outdrive? 1993 5.7L
  8. P

    OMC Cobra Does your prop lock in both directions?

    My Prop will rotate clockwise by hand when in forward gear engine off. Been told it's normal. Does your prop lock left and right when in forward? .
  9. P

    OMC 5.7 COBRA Valve tapping after W.O.T

    Puzzling new symptom from my 5.7 1993 OMC. After about 4-5 minutes at W.O.T. I slow to an Idle and hear a distinct valve tapping and dead miss. This will drift away over a minute or two and miss will too. I only have experience with lifter being flat at idle when first started Any body seen this...
  10. P

    OMC COBRA SHIFTING PROBLEMS

    I bought a 1993 SunBird with a 5.7L 350 Chevrolet OMC Cobra outdrive over a year ago. It ran great, shifted good. It broke loose of it's anchor when we were down in Florida on vacation and drifted into some rocks. Bent the prop shaft. Still ran and shifted good but had a vibration. Bought A...
Top