Search results

  1. S

    12' aluminum v-hull won't plane

    The original motor was a 8hp evinrude, so I upgraded to a 15hp evinrude. Still no luck. Could it be extremely bad luck and I got stuck with 2 bad motors? They both seemed to have ran perfectly fine. Or is it a weight factor? The old man that owned it before me outfitted it with 3/4 plywood front...
  2. S

    Please help!!

    I have a 1986 8hp Envirude model#E8RCDE. I just bought the boat from my neighbor so it had been sitting for some time. My question, I know the motor runs WHEN it starts, its very hit and miss. If I get it started and let it run for a bit it fires right up but if it sits for any longer then 12...
  3. S

    1986 8hp envirude, fuel mixture

    I'm new to the outboard world and I'm seeking advice on fuel to oil mixture. Its posted on the motor near the gas insert 100:1, my question, is this referring to the oil it's self, or do I mix it 100 parts oil to one gallon of fuel? I haven't ran the motor without the oil so no worries there...
  4. S

    1986 envirude choke

    Am I able to grease the pull choke? The reason I ask, it's a little stiff, and if your not careful and push it back in to fast/hard it dislodges the retaining clip dislodging the entire choke/primer plunger etc. If not any advice? It's pretty tight
  5. S

    8hp envirude gap settings?

    I'm not sure what the gap on the plugs need to be set at. Could someone inform me, or possibly let me know where to obtain such information?
  6. S

    12' won't plane

    I got a 12' aluminum v-hull with an envirude 8hp motor, the boat is moderately heavy (the old man put decks in) the engine has good compression great idle and throttle response. What would cause the boat not to plane? Even with just one person under 200 pounds it almost gets there but won't do...
  7. S

    8hp Johnson with internal gas tank

    A good friend of mine is selling me his boat, it has, what is labeled as a 8hp Johnson. I've been told that Johnson never made a motor that big with an internal tank. It has ports attatched for an external. Is this correct, is the motor miss labeled? Any help would be greatly appreciated
Top