Search results

  1. R

    96 Evinrude 50 Cutting Out

    The new hose is grey but it was my understanding that the new gray stuff is no longer problematic.
  2. R

    96 Evinrude 50 Cutting Out

    Well i was not able to get the boat back on the water, unless by chance one of these up coming weekends is very nice out (not likely) but i did read on the cdi troubleshooting page some interesting info. Heat sensor wire ran near plug wire can cause rf interference. Can also be faulty heat...
  3. R

    96 Evinrude 50 Cutting Out

    Wonderful… Wondering if its something to do with some type of heat soak issue. Not sure if I’ll be able to get it back out this year or not.
  4. R

    96 Evinrude 50 Cutting Out

    Both holes are 150 psi. Just tested now. I dont have a spare tank on hand I can try so I will have to see if I can borrow one. But the line is 1 year old Sierra replacement all the way to the tank. The tank itself is semi-built in but I was able to remove it last year and dumped the fuel and...
  5. R

    96 Evinrude 50 Cutting Out

    Thanks racerone i think of all the suggestions in post #12 i havent verified is the fuel pump diaphragm so i will look into that. Cylinder compression is good, but i do not know to test/verify crankcase compression?
  6. R

    96 Evinrude 50 Cutting Out

    Well i finally got the boat back out after the new coil, power pack and missing linkage rollers. Ran great around the lake. Shut it off for 10 or 15 minutes to eat. Then when we took back off, bam, it did it again. This is EXACTLY what it always does. After a hot lap or two around the lake...
  7. R

    96 Evinrude 50 Cutting Out

    Wondering if i should throw a power pack at it…. The motor is 28 years old. For ~$200 for a power pack and a coil would pay itself off in the weekend of messing around with it in the last remaining weekends of summer …
  8. R

    96 Evinrude 50 Cutting Out

    Saltchuckmatt, after reading this post i understand what you are saying about the jump test. Unfortunately I am bombed at work for the next few days (hence the pre emptive brainstorming). I will let you all know what I find asap. Thanks again
  9. R

    96 Evinrude 50 Cutting Out

    Not frusturated, just need to replicate the limp in order to diagnose. Some of these suggestions will yield nothing in the driveway as “it revs up fine in neutral”. I do appreciate the help, i have most of these tools so i will see what i come up with.
  10. R

    96 Evinrude 50 Cutting Out

    This I can do. Sounds like i may need to launch the boat to do it?
  11. R

    96 Evinrude 50 Cutting Out

    Saltchuckmatt what I am saying is i can only get it to “limp” when under a load. Meaning in gear, in the water, full speed ahead. I did not know of a way to spark jump test while cruising down the lake. Is it possible?
  12. R

    96 Evinrude 50 Cutting Out

    I have seen on mx bikes (coil on cap type) where bike will run fine until put under a load (1/2 or more throttle driving in gear) and bike falls on its face. This is what led me to believe coil. No i did not think a spark gap tool would capture this as i mentioned above but i will try it as its...
  13. R

    96 Evinrude 50 Cutting Out

    Ok thanks i will report back
  14. R

    96 Evinrude 50 Cutting Out

    Thanks I do own one. Worried i will get a “false reading” as it only acts up under a load. Going to give it a shot tho. What should the tool gap be set at?
  15. R

    96 Evinrude 50 Cutting Out

    Thanks i will look into these things. My thought about it running fine in neutral was it rules out a compression/fuel/spark issue. The intermittent nature of it i think definitely rules out compression. If you mean timer base not rotating, is that a common thing? I am just brainstorming here as...
  16. R

    96 Evinrude 50 Cutting Out

    Thank you, from memory i think it just has the one tan wire but i will confirm when i am by the boat
  17. R

    96 Evinrude 50 Cutting Out

    I had considered this while on the water. I checked the plugs (about the only thing i could really do at that time) and they looked identical, i.e, one wasnt soaked, indicating to me it was firing although i could definitely be wrong
  18. R

    96 Evinrude 50 Cutting Out

    Racerone I can check this on muffs. I do have a gap tester. I worry however because in neutral it revs right up great. Symptom is only noticed under a load where it can not pass about 2000 rpms
  19. R

    96 Evinrude 50 Cutting Out

    Model number is E50ESLEUS although I have never been able to find that model number in the break down so I use E50ESLEUR. It is a 2 cylinder Please elaborate on overheat diode? How do I check this? I did not get a overhead light on the dash so overheating did not come to mind.
  20. R

    96 Evinrude 50 Cutting Out

    Hey All. 96 Evinrude 50 SPL. Running great all season. Had it out today for a few hours. Was running at WOT and the power cut out suddenly to a limp. Motor sounded fine however (did not sound like it was missing). In neutral it will rev up just fine but under a load it was maybe like 20% power...
Top