Search results

  1. A

    98 115 4 cyl leaking trim pump/motor

    Got all my stuff together to winterize this week and while walking out I noticed the skeg and cavitation plate were wet. after a closer inspection I could see at the base of the trim motor where the square o ring is was soaked, after being trimmed up for a minute (required a little help trimming...
  2. A

    New to me 88 454 alpha one drive flush questions

    Had the boat about a month, its a 88 mach 1 23' condor with a 7.4 and a first gen alpha. To make a long story short less than 10 minutes after replacing the gimbal and bellows, the lower went. Snapped the vertical shaft right under the impeller housing. The boat was used in salt quite a bit so...
  3. A

    1976 55hp Evinrude running on 1 cylinder

    Here goes Bought the boat middle of last week, after about 3 hours of goofing around with my voltmeter I found the short the previous owner couldnt, fixed it and she fired right up. Ran fine on the hose off and on all day so I cleaned up my tools filled the tanks and away to the ramp we went...
  4. A

    Control Cables for 1976 Evinrude 55hp with johnson power point control

    Long story short I picked up an old "non running" cobia yesterday spent all evening chasing down electrical junk and when I finally got it all sorted and hooked up to the hose I realized that the cables are SUPER tight and the previous owner has broken the little cam dealy in the controls. will...
Top