Search results

  1. R

    Two questions

    I have 2 questions for you guys and gals who are much more knowledgeable than me: 1) My fuel gauge is stuck on "F". The gauge has 12 volts running to it and verified by my multimeter. When I took out the sending unit, all I got was the top portion and no rod or anything touching the gas line...
  2. R

    Alarm going off and trim up/down problems

    Mercruiser alpha 1 gen 2 I/O SeaRay 2010 17 ft. 1. My trim is stuck in up position. The pump seems to work and I don't hear any clicking from the solenoid. I checked the reservoir and it looks kinda pale but not milky white. The fuses appear good. Could the oil be the problem? The wires...
  3. R

    Spline and continuity washers

    Boat: 2010 Sea Ray I/O 17 1/2 foot Engine: Mercruiser 3.0 Alpha 1 Gen 2 I am trying to remove my prop but cannot figure out how to remove the spline washer. Is there a special tool for this? Rob
  4. R

    Gear oil leak

    Boat: 2010 SeaRay I/O 17 1/2 feet Engine: Mercruiser 3.0 Alpha 1 Gen 2 I noticed that gear oil was leaking out of water vents on the lower half so when I removed the lower half and in process of changing the impeller, I noticed that the oil seal carrier, carrier compartment, impeller and...
  5. R

    2009 Sea Ray 175 Bowrider 6 beeps

    Hello everyone: My boat just starting beeping 6 successive (very loud) beeps about 5 min after I start the boat. This is not the regular startup alarm before starting the boat. I noticed that the gas gauge was on "E" so I thought it was an alarm for low fuel so I put 10 gal of gas in it. The...
  6. R

    Sterndrive unit will not raise all the way up.

    Hello: I am a very new owner of a 2010 Sea Ray 175 bowrider I/O and a couple of weekends ago, my prop hit bottom and dented the prop. I thought I forgot to raise the drive but when I put it back on the lift, I noticed the sterndrive is not raising all the way. Maybe just one third of the way up...
Top