Search results

  1. C

    Minn Kota Heading Control Puck - Distance from Trolling Motor

    Confirming... consensus seems to be that getting the heading puck farther from the trolling motor doesn't add precision or anything to operation of the i-pilot, etc. Has anyone found that to be not the case? I'm mounting on a 16' aluminum boat... so mounting it right near the motor gives me...
  2. C

    '92 40 Mariner Magnum bad idle

    My brother has complained in the past that our 40 Magnum doesn't run along well at idle speed... meaning, in gear... putt-putting through shallows, no-wakes, etc. Well, I ran the engine for a while at idle, no problems. But, when I approached the landing to trailer the boat, I tilted the...
  3. C

    40 hp Mariner Magnum starter and brown wire

    I need to study my boat. Starter will only spin now, will never jump up to turn the flywheel. have seen posts about that possibly being a bad ground at battery or on block... i 'll have to check. second problem/issue. on the top of the engine, there is one brown wire with a quick connect...
  4. C

    Short in Mariner ignition switch?

    Ran the boat around today for a little while on the mariner 40 mag motor. Then trolled a bit. Went back to restart the main motor. Turned the key to start, choked a couple of times with the key, but motor didn't start.... but it was humming. I knew it had to be the starter spinning away...
  5. C

    40 Mariner Magnum - Install Tach?

    I'm looking at wiring up a tach to monitor the performance of my props. I've seen the teleflex wiring instructions....but am looking for some kind of instructions/walkthrough/pictures of where I'm actually hooking things up to the motor. (I'm good enough with doing mechanical/electrical...
  6. C

    Tore a Hustler

    I've got a Hustler prop that has seen relatively little use.<br /><br />Last weekend, I think I gouged it through a stump. put a tear in the prop that extends about 1/2" from tip of blade towards center. It also bent the prop at the tear so that it's about 1/8" offset at the tip of blade.<br...
  7. C

    Tore a Hustler

    I've got a Hustler prop that has seen relatively little use.<br /><br />Last weekend, I think I gouged it through a stump. put a tear in the prop that extends about 1/2" from tip of blade towards center. It also bent the prop at the tear so that it's about 1/8" offset at the tip of blade.<br...
  8. C

    Time to replace my X60 - updated

    Fishing that I do is usually confined to depths of less than 20 feet (I'm having a tough time thinking of the last time I was in water even 40 feet deep). Most is in rivers and reservoirs. Most are fairly stained (not clear).<br /><br />I'm hoping to get around problems I had in the past with...
Top