Search results

  1. B

    Trouble getting on plane

    1990 Johnson GT100<br />My Pee hole got clogged up with something (dirt probably). I noticed this after the engine was running. Since then i have had problems getting on plane for some reason. Once it gets on plane it runs fine, but i am having peoblems getting there. Any ideas are...
  2. B

    LU to Midsection Exhaust

    1990 Johnson 100 HP (Mod. # J100STLESB)<br />I just replaced the water pump on this motor. When I pulled the LU off the piece that that sits on the LU that goes in to the mid section exhaust housing needs to be replaced. I am very dory for the confusion, but my manual does not mention this...
  3. B

    Carb soaking

    I am going to rebuild my carbs. My factory manual says the carbs should not be soaked. However, from most post I have read and from talking to others, it seems that soaking them is highly recomended. Does anyone have any suggestions? I just don't want to damage anything. Thanks for any advice.
  4. B

    replacing water pump

    i am in the process of replacing the water pump on my motor. i have a few questions abou this process.<br /><br />1. Which way should the imepllar blades go in the housing?<br /><br />2. is there any other sealent that i can pick up at a parts store to use on the o-ring, rather than drive 30...
  5. B

    Jack Plate

    I have gotten to a point where i am going to do some work to my engine (rebuild carbs, water pump, etc.). it is a 1990 Johnson GT 100, and the boat is a 1982 venture bass boat. I want to get a little more performance out of the boat, mostly top end speed. I know the motor needs to be raised a...
  6. B

    starting problems

    I have a 1990 Johnson GT100. When i first start the engine for the day it starts fine. After it has been running for a while and i stop the engine to fish it is hard to crank back up. I usually have to turn the key 3 to 4 times to get it to start. Even then, I have to lift the idle lever...
  7. B

    Routine maintenance

    1990 Johnson GT 100. I have always changed the lower unit and spark plugs. I have bought some engine tuner that I am going to use tomorrow. I would like to change the fuel filter, but I can't seem to find it on this engine. Does anyone have any idea where it might be? Also, is there...
  8. B

    Idle Speed Problem

    1990 Johnson GT100. I have started having a problem when i am running in forward & reverse at idle speed. The engine almose seems like it is going to shut off. Almost like the enging is not getting enough gas. I just switched to a 19 pitch from a 17 pitch prop. I did not have this problem...
  9. B

    Transom Mount transducer

    I am going to mount my transducer to the transom of my bass boat. This is the setup i plan to use. please let me know if i am doing anything stupid, which has happened before :) I am going to try this to avoid drilling into the transom. <br /><br />1. Mount a piece of wood to the transom...
  10. B

    Tilt Trim Switch

    1990 Johnson GT100. The tilt/trim switch on my motor is not working. The switch on the control box is working fine. Should I assume that the switch on the motor is bad?
  11. B

    rectifier problem

    I have a 1990 Johnson GT100. I had a problem with the old tach. would run then shut off at times, then come back on. I bought a new tach. Same Problem. Saould I assume the problem is the Rectifier?
  12. B

    Stupidity at its finest

    I have a 1982 Venture bass boat. I bought it about two years ago and knew it was a fixer up boat. I saved enough money and finally got a trolling motor. As I was mounting the trolling motor this afternoon I accidentally drilled through the hull. OOPS!!! The hole was made by a 1/4 inch bit...
  13. B

    Lower unit plugs

    I need to replace the lower unit plugs on my 1990 Johnson GT 100. They have been rounded off som much that i have to remove them with a punch when i need to change the lower unit lube. Does anyone know if i could order them online. I do not live near a Dealer. Thanks for any replies.
  14. B

    Tach wiring

    I am not sure if i should post this here. if not i would be happy to move to another forum. 1990 Johnson GT 100 I have an old boat that i bought used. The tach. was hard wired instead of using a wiring harness to the OMC plug. Should i get another plug to put in the control box and run a...
  15. B

    RPM @ WOT

    have a 1990 Johnson GT 100. Does anyone know the Recomended RPM at WOT. Thanks for any replies.
  16. B

    Recarpeting Bass Boat

    I have gotten all of the old carpet up and finished getting all of the glue up( that was a pain). everyting under the carpet seems to be in pretty good shape. The floor seems to be pretty easy as far as laying the carpet. My question is, is there a certian way to carpet the storage box...
  17. B

    Prop Selection

    I am ready to upgrade from an AL. prop to SS. I have an 18' bass boat with a 1990 Johnson 100 HP. I am running a 14 Dia. x 17 Pitch now. Does anyone have any recomendations on prop selection? I am more interested in top end speed that hole shot. Thanks in advance for any advice.
  18. B

    Control Box Knob

    1990 Johnson GT 100 . There is a knob on the control box right below where the key goes. The knob turns left and right. I have no idea what this knob does. Anyone have any ideas? Thanks in advance.
  19. B

    Year of Motor

    I have a johnson GT 100. When I bought it the company told me it was a 1989. I am trying to order a manual and it seems that from the model # it might be a 1990. I just don't want to order the wrong manual. the model # is J100STLESB . Any help is appreiiated.
  20. B

    Repair Manual

    Johnson GT 100, 1989. Does anyone know where i could get a manufactor repair manual, or the next best thing? I need to check my clutch dog and i can't figure out how to get to it. thanks.
Top