Search results

  1. B

    steeringcable?

    Seeking advice ! I have a 1978 Ivader outboard with a steering cable getting hard to steer Is it best to replace cable or can it be lubricated ? motor turns good without cable mounted! BOAT SAFE!!
  2. B

    105chrysler carbs leak in transport?

    When I tow my boat to the lake I have my motor in tilt position,before I launch I noticed a small amount of gas has leaked out of the mouth of the carbs. Is the pressure in the portable gas tanks doing this or do the carbs need rebuilding? When motor is in normal position no leak occurs.
  3. B

    Do I need washers on water pump bolts?

    My new water pump housing uses bolts instead of screws on original pump."BRIGHT IDEA!" Now should I use washers on the replacement bolts that came with unit?
  4. B

    water pump bolts ?

    What can I use on water pump bolts to make them come out easy when I service it next time. teflon tape,etc.
  5. B

    Snapped Bolt ?

    A 5/16 bolt has snapped off flush with motor. I would like to remove without damaging female threads,but I do not have a tap/die set. So I drilled a 1/8 hole through center. Is there a reverse thread self tapping bolt I could get or shold I try increasing drill bit sizes in order to get it out.
  6. B

    105 chrysler outboard in danger ?

    Having removed the lower unit after a small oil leak in weep hole,lower unit seals looked fine,however noticed oil like leak coming from exhaust port.What could it be?
Top