Search results

  1. P

    150 Johnson 1987 VRO to fuel pump

    Does anyone know if there is a fuel pump that can replace the vro pump and are there any other items that need to be plugged, disconnected , removed The pump is plugged at motor area ,plan to remove vro tank .If this is possible to change to a fuel pump what part number is it ? , do we need to...
  2. P

    150hp Johnson 1987

    Good afternoon hopefully everyone is well have a new project and a new problem motor runs fine on a hose or idling in the water but is soon as you throttle up the motor bogs down but eventually dies any help here would be greatly appreciated
  3. P

    70 hp force 1991-1995 prop

    Can anyone tell me how to size a prop There are no numbers stamped on it except Michigan 142003 when I look it up on iboats it comes up as A prop for a Nissan nothing about a force I'm pretty sure this prop is a original to the boat and motor The RPM s seem to be very close it planes ok...
  4. P

    70 force prop

    Does any one know if Michigan part number 142003 Is the correct prop for our 70 hp force 1991 1995 engine when I looked it up on iboats it came as a total different engine make .also what does 10-3/10 for diameter equal and what does 12-7/10 for pitch is this the correct prop or are they using...
  5. P

    70hp force flywheel

    Thanks for your help last time guys I lapped the flywheel replace the keyway ,locking nut ,torque the flywheel to 85 foot-pounds we trolled for six hours caught 17 striper on the way back to the launch the flywheel Spun again what are the chances I can get a new flywheel or replacement...
  6. P

    70 hp force broken keyway

    The keyway has sheared and was wondering if any Other damage could have happened .i know it has no valves but ? Also what caused this ?carb issue ?/ timeing ? Fuel is fresh and mixed correct or is it possible we did not tighten the flywheel nut correctly when new Stator was installed
  7. P

    Help with tilt /trim King pin removal

    Cannot get the King pin to budge removed the Kotter pin tried to tap it with 3 lb hammer several Times with pbblast soaking still no movement Any help would be great trying to ready for fall striper but cannot get trim ram out its 96 force Mercury 70
Top