Search results

  1. A

    Need to identify my shifter

    Yes the mercruiser is original
  2. A

    Need to identify my shifter

    I am trying to identify the make of shifter that I have in my 1994 Wellcraft eclipse 196. The engine is a 5.0 mercruiser. Here is a pic
  3. A

    Commander 3000 control question

    I just put a quicksilver commander on my 77 arrowglass that I am restoring. It has a 140 86 alpha drive 140hp. The controls had very little use and work easy. But when I put the shifter in forward or reverse the accelerator cable moves just enough to raise the rpms 200-300 above idle rpm...
  4. A

    Motor mount dimensions

    I have a 77 arrowglass with a 1977 3.0 mercrusier in it. I am taking out the entire unit and replacing it with a completely rebuilt 1988 3.0 mercuser alpha 1. The new rebuilt apha 1 will include motor , transom plate, bell and outdrive. Will I have to change my current transom cut out or the...
  5. A

    Carb power valve operation question

    Rebuilding my mercrusier 2 bbl carb 1389-9562. In the base of the bowl there is a power valve and in the air horn there is a spring loaded piston that is supposed to retract under vacuum thus closing the power valve. The problem is that I can't get it to retract if I put vaccum in the hole...
  6. A

    Engine dieing on hard throttle

    Thanks to the helpful members on this forum I finally rewired my 88 3.0 that which has DDIS. Someone had cut off all the copper wire before I got the boat. So I don't know much about the engine before that. The motor started right up and runs smooth. It idles well. The problem is , if you give...
  7. A

    Block swap question

    Just found out today that the 1988 alpha 1 3.0 block is cracked in a boat I am restoring. I do have on hand a 1977 mercrusier 3.0 block that is rebuildable. Will this block match up to everything on the 88. I also have the crank shaft to this block. Can I use the 88 crank shaft with this 77 block?
  8. A

    Piston ring clearance

    I am rebuilding a 3.0. I had 110psi compression in each cylinder and needed to find out why the low compression. When I tore down the engine I found that the side clearance from ring to groove was .006 on all the top rings on all the pistons. In looking at the shop manual that engine calls for...
  9. A

    DDSI back to distributor

    I have a 1988 3.0 that has the DDSI system. I am considering going back to distributor with a petronix inside. I have a good distributor out of a 1977 3.0. Will this distributor work in a 1988 if I add a coil.
  10. A

    Pressure testing a 3.0 head

    Can someone explain the metho of pressure testing a 3.0 head. Specifically I would like to know what psi and duration that it should be tested for. Has anyone tested a pressurized head with soapy water
  11. A

    Wiring for digital iginition

    Restoring a 88 boat with alpha 1 3.0 which has digital ign. Problem is someone cut all the copper wire out of boat but left about 2 inches of wire at each location. I would like to replace the wiring by splicing in new wiring. I need to know where the different colors go to on the iginition...
Top