Search results

  1. M

    Pontoon navigation lights wiring.

    Thanks roscore. I’ve updated my drawing. I’ll make a better one if this correct.
  2. M

    Pontoon navigation lights wiring.

    Thanks for the reference. That is close, but missing the fuse panel. I’m assuming the +12v goes to the fuse panel and the negative lines also go to the fuse panel. Also, since the bow lights on the pontoon is actually 2 separate lights im not entirely sure if they are wired in parallel or...
  3. M

    Pontoon navigation lights wiring.

    Real purty, and simple….as you might guess, I did it myself….should have asked an 8 year old to draw it, lol! I’ll have to check the switch in the morning. I’ll include a picture if I can.
  4. M

    Pontoon navigation lights wiring.

    Most of the photo links are broken In the sticky section….unless I’m doing something wrong.
  5. M

    Pontoon navigation lights wiring.

    I’ve searched and searched. Honestly. But I cant find a simple diagram showing the wiring for navigation lights that include separate port and starboard lights, stern light, switch, fuse panel and battery. I know the wiring of the switch itself will be some what dependent on the type of switch...
  6. M

    Still, still stuck with no spark

    I’ve solved my problem from the below thread (sorry, not sure the best way to link the thread) The solution is called a 2022 Suzuki 50hp. works like a charm now!! (the bank is happy too!) https://forums.iboats.com/threads/still-still-stuck-with-no-spark.765059/#post-5846684
  7. M

    Still, still stuck with no spark

    It’s the black 16 amp stator for reference. At cranking speed on a fully charged battery on low speed (blue wire) it is 245. High speed (red wire) it is 15. My rpm gauge isn’t working so I’m not certain of the rpms. Service manual calls for low speed 160-200 @ 300 rpms and 315-385 @ 1000 and...
  8. M

    Still, still stuck with no spark

    I checked the ground wires for the coil. Each coil has its own ground wire. Two are attached to the upper mount bolt and two to the lower mount bolt (mount bolt for the switch box). These are securely attached. Thanks again for the suggestion.
  9. M

    Still, still stuck with no spark

    Thanks. Ya, my new switch box has that ground wire also. I attached it to the mounting bolt for the switch box, along with the other ground wires for the coil.
  10. M

    Still, still stuck with no spark

    Thanks. I’ll check the ground on coils. But if I remember, each coil is individually grounded. All coils have no voltage. Ill check the trigger again and also trace the wires To check them. Thanks for the additional leads!
  11. M

    Still, still stuck with no spark

    Lol, that’s about my knowledge too! regarding the stopper switch (or the kill switch and or the tilt switch, the motor doesn’t have them.
  12. M

    Still, still stuck with no spark

    Thanks for the suggestions. yup, I’ve removed the black/yellow from the switch box. regarding the multimeter, I bought the DVA to attach to the meter in order to read the voltage. Voltage from the stator is good. No voltage is coming out of the switch box into the ignition coil.
  13. M

    Still, still stuck with no spark

    Hi all. I posted a thread about this last year and still struggling with it, so reaching out again for help. I’ve done additional test steps, but to summarize: On my second trip out on my new to me 1996 Mariner (see signature for detail) my engine just quit. No sputter, coughs or bangs...
  14. M

    Diagnosing trim gauge issues

    Thanks for everyone’s input! Winner was…….the sending wire got disconnected in the engine compartment, likely when I was replacing the steering cable last year! Your help is much appreciated!! On to seal kit replacement of the upper gear case. Damn, will the ever end!!!
  15. M

    Stalling and Starting problems

    Hey amplay. I had the same sort of problem last year. Would idle ok, troll speed ok but when I go wide open it would stall out then hard to start. Once I got it started again, the same thing would happen all over again. Im almost positive it was water in the gas. I put a full can seafoam in the...
  16. M

    Diagnosing trim gauge issues

    My trim gauge stopped working late last year. The weather has finally turned better and it time to fix it. I’ve tested the gauge using directions found here in the forums and it appears ok. Trim up/down and trailer up/down have no impact on the gauge. With the key off or on the needle remains...
  17. M

    Still stuck with with no spark

    Hmm, that’s an idea. I guess that would be the two yellow leads?
  18. M

    Still stuck with with no spark

    Yup, tried that. Thanks for the suggestion. I’m starting to think it’s something simple. I’ve done a bunch of research, but nothing else seems to be coming up.
  19. M

    Still stuck with with no spark

    Slowly making my way through the elimination process but still no spark. - Checked all plugs (using an inline spark tester). - Stator ohm’s tests ok (however, a new stator was installed at the direction of the mechanic (and that's another story!!!)). - Switch Box (new box installed). - Trigger...
  20. M

    How to install flywheel

    Excellent! Thank you very much!
Top