Search results

  1. B

    Kodiak 225 Brake pad replacement

    Time for me to replace my pads and I'm wondering if there is a automotive equivalent to the kodiak 225 pads. If there is, is there any difference in using those pads vs buying from kodiak?
  2. B

    Navionics maps on Lowrance chart plotter

    So I knew Garmin bought out Navionics but I discovered today that the old web address to Navionic's web chart viewer redirects to a Garmin web address. It's great that the web chart viewer is still accessible but I can no longer do auto-routing for a trip. 1. Are there any other web based chart...
  3. B

    Bravo 3 carrier assembly seal be damaged this way?

    I park my trailer on a gravel pad and a couple of weeks ago I noticed that the outdrive was in the full down position with the skeg buried into the gravel along with some of the prop pushing into the gravel. Long story short, I'm guessing one of the rain storms probably seeped into the swim...
  4. B

    EX Lube bearings on new to me trailer, how often to physically check bearings?

    I have easy lubes as well. I'm a little OCD when it comes to the bearings so I actually pull everything apart each year to inspect the bearings and put fresh grease in at that point. In my opinion, if you don't check every year, you won't see the warning signs and something will fail at the...
  5. B

    Trailer brake pad uneven wear

    Thanks....I caught that after looking at kodiak's site... not sure why I missed what to lube in the first place 😖
  6. B

    Trailer brake pad uneven wear

    That's the other thing I realized this time....these calipers seem to slide on the caliper bolt sleeves within the rubber bushings. The caliper bolts seem to hold the sleeve in place against the bracket. I've been lubing the wrong part....needed to lube the sleeve in the bushing.
  7. B

    Trailer brake pad uneven wear

    I installed the Kodiak 225 brake kit about 3 years ago and only noticed this time around that the brake pads are wearing unevenly, I think. The outer pad is significantly thinner than the inner pad (one on the piston). I've always thought that both pads would wear down fairly evenly. I'm OCD...
  8. B

    First startup for the season and then died

    That's why I get my fuel at more reputable places even though there is one station near me that sells it way cheaper which would be nicer on my wallet....but you got to wonder why it's so much cheaper than all the other stations around :) Thinking some more on this, it did seem like I had...
  9. B

    First startup for the season and then died

    Yes, I put the stabilizer in on a full tank and go for a short run to burn the tank down so I have somewhere between 3/4 to 7/8 tank over the winter. If this is water, it would be a first as my winterization routine has been the same every year.
  10. B

    First startup for the season and then died

    I have the cool fuel gen 3. I will check. Assume it is water, how do I get rid of it? I have an 80 gallon tank.
  11. B

    First startup for the season and then died

    Not sure if you mean water in the tank? Fuel filter was replaced when I put the injectors back in.
  12. B

    First startup for the season and then died

    It's in my signature unless it's not showing. Anyways, it's a 2005 MX 6.2 MPI w/Bravo 3. It's under 300 hrs.
  13. B

    First startup for the season and then died

    First engine start for the season. It started up and ran rough for a minute or two like it wanted to stall and then died. Now it won't restart. At times it sounds like it wants to but doesn't catch. During one start attempt, it made a pop/hiss sound and blew the IAC filter out of the...
  14. B

    Fuel Injector Question

    Next question because I can't seem to find the answer in the service manual. What kind of o-ring lube to use? I googled it and the answers are all over the place....use engine oil, ATF, silicone, vaseline. Which one is it?
  15. B

    Fuel Injector Question

    No need to worry now.....went back and looked and found them sitting in the port. Whew!
  16. B

    Fuel Injector Question

    I went to pull the fuel injectors so I could send them off to be cleaned. Since this is a 2005 boat, this is probably the first time they've been pulled and they gave me a little bit of a fight. Some of the injectors popped off the rail rather than out of the manifold so I hope I didn't do any...
  17. B

    Battery charger size needed

    Thanks for the info!
  18. B

    How to get Navionics on a large screen at the Helm

    You can get Navionics on Garmin. Garmin bought Navionics not too long ago. Also Lowrance supports Navionics. I've been using a Lowrance GPS for the last 5 years along with a Navionics subscription to keep the charts up to date. I love the sonar cartography.
  19. B

    Battery charger size needed

    I've been reading up on how to determine what size charger is needed. Some things I've read is to take the amp hour rating and multiply by 10%. Based on this, it looks like I would need a 20 amp charger (10 amps per channel - 2 batts). But then I've also read that I wouldn't need a 20 amp...
  20. B

    Fuel Pressure Regulator - Automotive equivalent

    Why are some regulators way more expensive than others? For my engine (2005 6.2L MPI), 885174, it averages around $300. I know there have been many posts regarding the use of Merc parts versus the automotive equivalents. Is there an automotive equivalent for this regulator? I know there are...
Top