Search results

  1. D

    88 200 Black Max rebuild, should I?

    Just rebuilding from results of 2 main bearings cracking and seizing the motor. Never seen this, but am considering removing oil injection and pre-mixing. No problems, just think that it would eliminate many possible hazards. Cant afford another round of this, and dont really see that there is a...
  2. D

    seized piston

    Had a piston seize, but not from lack of cooling. Must have been a carb going lean! What can safeguard against this in future. I Do all the preventative maintenance and then some???? The engine was purring like a kitten and running cool. Had just cranked it up and was idling along!!! Plugs all...
  3. D

    88 Mercury 200 Black Max

    Had a piston seize, but not from lack of cooling. Must have been a carb going lean! What can safeguard against this in future. I Do all the preventative maintenance and then some???? The engine was purring like a kitten and running cool. Had just cranked it up and was idling along!!! Plugs all...
  4. D

    Mercury powerhead???

    What would cause a piston to seize in the cylinder if the engine did not show HOT on temp gauge? Mercury 200 Black Max
  5. D

    88 Mercury Black Max Powerhead

    Engine was idling along, running cool when it seemed to run out of gas or either bog down. Now cannot turn over. Could it likely be lower unit? Can still turn prop in neutral. Do I need to drop lower unit to verify not it or would this not be a probable cause?
  6. D

    powerhead locked up

    Replaced water pump, poppet valve, and thermostats and engine was running cool. I was idling along and engine sounded like it run out of gas or bogged down. Would not turn over after that. Cant turn engine with flywheel? What happened? Was running cool and fine!!!! :mad:
  7. D

    running hot at high rpms

    If water pump, thermostats, & poppet valve all replaced, what would make motor run hot at high rpms. Seals, tubing and everything in water circulating system seems to be working correctly, what next. Can I check sending units, but doubtful its that. The engine really seems hot, but runs and...
  8. D

    poppet and water pressure

    Will poppet valve on 88 200 Black max mercury cause water pressure to drop to 0 at 4500 rpms if it were bad? What would cause water pressure to be 0 at idling then rise to 10 with rpm increase and then fall back to 0 at 4500 rpms?
  9. D

    poppet valve help

    Will a poppet valve cause water pressure to drop from 10 to 0 around 4500 rpms. I have a 88 200 Mercury balck max. It doesnt seem as if the impellor in the pump was the problem. Is there much to replacing a poppet on this year and should the thermostats be done also since they are about 9 years...
  10. D

    overheating and loss of pressure

    I have a 88 200 Black Max. Idling runs hot and has 1-2 lbs. of water pressure. Taking off, as my rpms increase the water pressure jumps from 0 to 10 and temp goes down to midrange, once rpms hit 4500, water pressure drops instantly to 0 and temp goes instantly to hot. Pulle lower unit and...
Top