Search results

  1. J

    Evinrude prop assembly part ID needed

    Hello, I removed my prop to clean and grease the shaft and after removing the thrust bushing {part# 0334590** there sat a severely worn very thin plastic o-ring of some sort. Sat directly behind the thrust bushing. Would anyone know if this sits inside the groove in the actual thrust bushing, or...
  2. J

    Paint for aluminum boat?

    Hi, I have a 14' aluminum boat, currently has paint but considering repainting. Used in saltwater and fresh. Not stored in slip. What type paint do I use, and is the entire bottom typically painted as well? Above waterline paint is mostly in good shape. Below waterline there are some bare...
  3. J

    Water pump install

    Hello, I am trying to fit the impeller and key pin { while inside the metal cup } over the shaft and it just won't slide down.Must be a trick to this that I am missing. 1994 Evinrude 9.9 E10ELERB. When I do eventually get it down, is the key pin supposed to align within the flattenned out area...
  4. J

    Water pump removal

    Hello, I have a 1994 Evinrude 9.9 HP, model E10ELERB { long shaft } engine and plan on installing a new water pump. After I loosen the bolts for the lower unit, I understand that I have to loosen the 2 bolts that hold the shift shaft in place. First question is, do the end of these bolts simply...
  5. J

    Evinrude long shaft to short

    Hi, I have an Evinrude 9.9 hp long shaft and have heard of a conversion to short shaft by way of some sort of bracket mounted on the transom that raises the entire engine up. This avoids the mechanical coversion and parts. Has anyone heard of this?
  6. J

    Mystery Merc problem

    Hello all - Have a problem with a 2001 20hp Mercury. The motor will only start with the center bolt of the exhaust manifold cover fully loosened.There are 9 bolts holding this cover on.I noticed the center one was loose,so I tightened it while it was running and it stalled.Loosened it and it...
Top