Search results

  1. W

    Getting "old" fuel out of onboard fuel tank

    I have just cleaned and put new kits in the carbs of my 1999 Johnson 90hp. I want to empty the old fuel( about two years old) from the onboard fuel tank. I have used the primer bulb to start it to siphon, but have not been sucessful. Any ideas would help. <br />It has been suggested that when I...
  2. W

    1999Johnson 90hp will not start...help please....

    1999 Johnson 90 hp. model numberJ90PLEEB ; serial number 044671325. Compression is 140 on all 4 cyl..... rerplaced fuel filter and squeeze bulb..... disconected fuel line from on-board fuel tank and am using fuel from shop tank. Have installed new plugs. my spark tester shows good blue fire...
  3. W

    Which is better,60 or 90 degree???

    I have a Johnson 90hp, 1999 Model # J90PLEEB; Ser# 04671325. I need to clean and perhaps put kits in the carbs. Is there a difference in the carbs between the 60 and the 90 degree and How can I know whick engine I have ????<br />Thanks,<br />Paul
  4. W

    Need Shop Manual for Johnson 90h.p. 1999

    I took my Johnson 90hp,199,Model J90PLEEB,Serial <br />04671325... to a dealer last fall to have the engine prepared for winter(cost $300.00). When I try to start it, it will not start. I have fire to the plugs, new gas, and a good battery. When I called the dealer I was told that I needed to...
  5. W

    how do I get the air out ot tnt cyl on 120 Hp E venrude 19888

    Just put new orings in the tilt cyl cannot get it to go up or down. Seems like there is air in it. How do you purge the system?<br />Thanks,<br />Paul
  6. W

    trouble in repairing tilt cyl on 1988 Evenrude 120

    Need help.... I have replaced the o-rings in the tilt cyl... filled with oil... cannot get the cyl to work up or down. The two cyl at the bottom(trim ??) do go in and out but the upright cyl (tilt cyl) does not move. Note : I have the motor disconnected from the eye bolt and is tipped over...
  7. W

    1988 Evenrude 120 hp..tilt motor will not raise engine

    Just replaced the tilt cyl internal o-rings...filled with oil.... engine went down... will not raise....mtor and pump are working. cannot manually raise the engine.<br />Hope you can suggest what I can do. Thanks
  8. W

    trouble with tnt cyl, ...will not raise engine

    1988 Evenrude 20 hp. just replaced all the internal o-rings in the tilt cyl. filled with fluid .... motor and pump seems to work.... will not raise the engine.<br /><br />Do I need to bleed the lines???? Sholud the slotted pluge on the left side{not the fill plug} be tight or turned a certain...
  9. W

    remove,repair and reinstall tilt cylinder on 1989 ,120 hp,Evenrude

    NEED YOUR HELP GETTING THE PIN OUT AND THEN REPLACING THE O-RINGS AND PACKING IN THIS CYLIINDER....I HAVE THE ENGINE TILTED UP AND THE RELEASE VALVE ON THE LEFT SIDE OPEN. i ALSO HAVE THE FILL PLUG OUT.<br />Sure appreciate any and all help...Thanks<br />Paul
Top