Search results

  1. J

    Looking for info on older bay boat

    1995 “KruggerBrand Baymaster” 18’ CC tunnel hull. Recently acquired through a trade for an old truck I had sitting around. Powered by a 1996 135 Mercury. Good boat no issues with it, transom seems solid. One small soft spot around a hatch in the floor near the bow, has a bad seal around the...
  2. J

    Hard Freeze Preventative Maintenance

    I live in southeast Texas, our winters are very mild, so mild in fact I’ve never had to winterize my boat before. Neither has anyone else I know in my fishing community. Everyone fishes pretty much all year around as our winters are typically in 50s during the days and 40s at the coldest, if we...
  3. J

    1995 Mercury 135 won’t go higher than 2000 rpm WOT

    Was out on the water a few weeks ago and my primer bulb split. I was able to run about 1/4 throttle to make it back to the ramp. Anything higher and motor would die. The next day I put a new bulb on and took it out for a spin, no issues was on the water all day long. Unfortunately I was in the...
  4. J

    Hydraulic Jackplate Wont Lift

    CMC Powerlift (PL-65). Motor is all the way down, the toggle control kind of gurgles for a second and stops. The electrical is all good and ive been told my mechanic the accuator needs to be replaced. However its 400 for the part and another 300 for labor. He also mentioned there was a way to...
  5. J

    Old Speaker Hole Patch Job

    Recently acquired an 18 ft krugerrbrand baymaster, the previous owner had 6” marine speakers mounted in the the two storage/seats up front. Down below facing the center console. I don’t want to put new ones in and would like to patch up the holes. I need those boxes for storage and it doesn’t...
  6. J

    Starter bendix will not stay engaged

    Motor is an 89 25 hp. Bendix only engages flywheel for about 1 second sometimes 2. I've lubed the shaft and cleaned connections. It has only recently started doing this. What is odd is I did a compression check and when the spark plugs were pulled the bendix would stay engaged as long as I had...
  7. J

    1989 Johnson 25 HP Fuel Pump Test

    Is there a way to test a fuel pump. I cant seem to find anything online, just rebuild videos but nothing that says what to look for to verify a pump needs to be replaced or rebuilt. I have good spark on the plugs and compression is 90/90. If I can get the motor started it only runs for about 10...
  8. J

    1989 Johnson 25 HP. Multiple Issues

    Picked this motor up for close to nothing knowing it needed some work. First round of maintenance as follows. water pump/impeller Thermostat carb pulled and cleaned Fuel lines flushed Motor ran okay aside from it taking a while to get it started but once warm it was fine. Fourth time out...
Top