Search results

  1. O

    1993 E48 ESLETE

    Bought used and took to local "Evinrude" dealer for tune up. We took it out with fresh fuel and ran for about 20 minutes, then !BANG! threw a rod in top cylinder. Cant find any to buy so I ordered a short block. I have started the new block but it had no fire in top cylinder so I put a new coil...
  2. O

    93 Evinrude SP48

    Thank you for the part number and the adjustment YouTube. I'm very grateful for this group for sharing expertise that's not available anywhere else.
  3. O

    93 Evinrude SP48

    Motor runs fine but I think the linkage is not adjusted correctly and a white sleeve on a link is breaking off. I need a picture of the linkage in the idle position and a source for the part. This motor has zero wear and I'll appreciate any advice. It's going on a 22 ft pontoon.
  4. O

    New 1993 Evinrude 48spl

    Thank you all for the advice . I have checked the carbs and cylinders both had been lubed before storage and look like new. I put it in a big trash can full of water and turned the key to hear a perfect quite humming motor. I'll pull the lower to check and replace the water pump impeller when...
  5. O

    New 1993 Evinrude 48spl

    Thank you! That rubber is probably deteriorated after all these years. Ordering one today.
  6. O

    New 1993 Evinrude 48spl

    New owner of pontoon boat and motor. Believe it or not the engine has NEVER been used, but sat on the boat at a dock in fresh water until last month, I'm waiting for a gas tank and lines in order to try to start it and would appreciate any advice about what to be careful about to avoid damage...
  7. O

    Just bought a 93 48spl

    Thanks... I was just about to trash it.
  8. O

    Just bought a 93 48spl

    Does the fuel line require 2 hoses (1fuel- 1 air). Just got the engine but the fuel tank and hoses don't fit. Is there an on line manual available? I'm very experienced with 2 stroke motorcycles but new to the outboards. Motor going on a 21 ft pontoon boat.
Top