Search results

  1. R

    Tohatsu. question

    Hello, I am a beginner at outboards and I noticed that when I go to flush my motor after being out on the water it doesn't pee. This is not a problem on the water only when I flush it regardless of if I use muffs or submerge it into a trash can of water. Is this something to be concerned about...
  2. R

    Engine cutting off

    Yes it has the Manuel vent opened.
  3. R

    Engine cutting off

    2019 Tohatsu 15hp
  4. R

    Engine cutting off

    Hello. Can someone give me an opinion on why my motor dies after about 5 minutes of running. I notice that when it dies I try to prime the bulb and it won’t pull gas from the tank. After I get home and has sat I try and it primes. It’s like once I start it and get moving it isn’t pulling gas...
  5. R

    Engine cutting off

    Hello, Im new to owning a boat. I have a tohatsu 15 hp that primes,, starts and runs fine until about 10 minutes of running then it dies. I noticed when it does this the bulb will not prime at that time. I feel like the engine is getting gas. after I wait a while maybe 20 minutes or so it will...
  6. R

    Trim and tilt question

    It runs but comes out of the water. And I have to trim it waaaaay down
  7. R

    Trim and tilt question

  8. R

    Trim and tilt question

    So the holes that would be there after I remove the plate. I would just fill them marine sealant? Like I said this is all new to me man. I was actually thinking of trying to add a lower plate to the existing plate just lower. Don't know if that'll work. I'll have to think about it for a few and...
  9. R

    Trim and tilt question

    It’s trim n tilt. But it’s mounted so high the propeller is high damn near even with the bottom of the boat unless tilt it down a ways
  10. R

    Trim and tilt question

  11. R

    Trim and tilt question

    It only tilts down and up. It does go down and up vertically.
  12. R

    Trim and tilt question

    Hello, Im new to having a boat. I have a 14 foot jon boat. The previous owner put a electric tilt and trim plate on it. the plate has the motor sitting high. High enough that the the prop is almost at the level of the bottom of the boat. It has to be trimmed way down. is there any ideals on...
  13. R

    Any Sea nymph owners here?

    What are the switches one the console that are not the Blidge. Horn, live well
  14. R

    Should I winterize my boat?

    Hello, Im a new boat owner. I live in NE Florida, the temps in the winter do get down in the 30s and 40s on occasion but usually not for more then a week or two. I still plan on using my boat in the winter here. Do I need to do anything to winterize it?
  15. R

    Johnson 50hp

    prime the gas bulb, push in the choke a few times. Turn the key. I was recently told to push in while turning the key. I've only had the motor less then a month. It was fine the first few times out.
  16. R

    Johnson 50hp

    I am pushing it in to choke then I turn the key without pushing.
  17. R

    Johnson 50hp

    Just bought it its a 99 johnson 2 stoke
  18. R

    Johnson 50hp

    I have a 99 Johnson 2 stroke that runs good but takes long to start. I spray starter fluid in the carbs, starts right up. Any suggestions what could be going on?
  19. R

    Size of outboard

    Thanks. I'm not much into speed. Just wat to fish on the weekends. The boat is light and planes easily.
  20. R

    Size of outboard

    Hello, Im a newbie to boating. I have a 16 ft 1999 sea nymph 160 fm. It is rated to up to 70 hp. I don't think i Need that nor can I afford that. Will I be good with a 30-40 hp on it. I won't have more then 3 people onboard at a time.
Top