We just picked up a 99 sunesta 233 and I can't find a y instructions on how the porta potty works. I've tried youtubeetc with no luck. Also looking for info on how the fresh water system works.
Any help will be greatly appreciated!!!
Thanks Fred
Hey Folks!
Im looking at a Regal Valanti 29' boat right now and I think theres a very good chance I will pull the trigger on it...its just beautiful and has been meticulously maintained. The ONLY issue is the cover. It has a mooring cover but I would like to look into a full camper for it and I...
So you don't think layering and sanding fiberglass will be necessary? I'm all for a putty and sand repair!
This caught my eye on amazon.
Marine Coat One Iso/Npg Marine Gel Coat White with Wax with MEKP Catalyst for Hardening, Gel Coat Repair Kit for Boats, Fiberglass and More
The boat made hard contact with the dock when teaching wife how to softly approach the dock. She brought it in perfectly and I stepped off with the lines, she gunned it and all hell broke loose. Thankfully the damage in the picture is all that happened and other than rope burns on my hands...
Well it seems that these engines run much better with the cut-off tether installed. Holy crap what a dope I am! I saw that when I was looking at the ignition switch. It runs great now. Now I add that to the pre-start list...
I just installed a new carb on my 91 3.0 mercruiser. its an aftermarket but I dont think that is the issue. When I turn the key to start the engine it will fire right up and when I release the key it dies. If I increase the throttle and turn the key it will start on the corresponding increased...
I did mess with the screw when we were on the water and of course I lost track of the original position while disassembling the carb 3 times on the water :)
3.0 liter mercruiser, yesterday the carb started flooding badly while on the water. I disassembled the carb in the boat and seem to have fixed the problem but the gasket got torn and I am going to rebuild it. My question is the initial setting for the low speed idle. I will be setting it up on...
Trim and speedo.
Trim motor works fine with no problems at all. When trimming down the unit will work flawlessly but the guage stops registering trim at halfway. I did remove the trim sender as I thought maybe that was the issue and all I would have to do was reset the drive gear on the unit and...
The steering problem has been cured. between the weight distribution, anode adjustment and trimming I can now find the sweet spot and the boat handles great! thanks for the help guys!
