Search results

  1. B

    Water between stationary mount and lower unit?

    No one here was able to answer my question, but I did get an answer so assuming this question may arise again (I cannot be the ONLY idiot), I'll post here what I found out from my local yamaha mechanic. On these motors, it is normal for water to be found between the arrows in the attached...
  2. B

    Water between stationary mount and lower unit?

    Mike: Thanks for getting back to me. I don’t have a video, but hopefully the attached photo will help. I need to know if there is normally water in the section between the metal on metal seam at A and the rubber ring just above B. I can’t imagine there wouldn’t be, given that the drive shaft...
  3. B

    Water between stationary mount and lower unit?

    I have a small (F6) four stroke yamaha outboard. I note that small amounts of water leak out around the rubber gasket between the transom mounted section and the pivoting lower unit. Also, water escapes from the hole where the shifter shaft extends upward to the power unit. Never noticed this...
  4. B

    Yamaha F6 post-impeller replacement question

    I have a Yamaha F6 hp 4 stroke outboard. It being 7 years old now, I decided to replace the impeller. I have the manual and followed the directions carefully, and installed a new impeller and fiber gasket on the water pump base, re assembled and test ran in a tank. All seems fine (good flow of...
Top