Search results

  1. L

    In the beginning the compression was low ...

    A long shot but I'll mention this to my dad's old friend. British, retired, engineer (and though retired still partly owns the engineering company he set up), been into boating all his life, knows his way around engines, used to regularly drive to Italy to pick up and deliver stuff for his...
  2. L

    Hull cleaning

    Thanks, I'll remember that for next time. Does chalking imply any damage to gelcoat or is it the stuff itself crystalising?
  3. L

    Fluctating Voltage

    There might not be much wrong with the alternator.. Not too unusual for voltage at idle to be around 13.8v if there are other electrical loads besides just the ignition system / fuel pump and fuel injection system. At around 13.8v the battery might not be getting a good charge but it won't be...
  4. L

    I/O (Sterndrive) Conversion to Outboards

    I might expect the engines to become a little more economical when run in but I would think it difficult to judge when they're run in on that basis. Wouldn't it need to rely on you already knowing fuel economy for fully run-in engines, while you probably won't know that unless you've already...
  5. L

    Hull cleaning

    I've used oxalic acid only once to get rid of small rust stains on the swim platform and remove water marks from the hull,. Works well but seemed to leave a dust film which I removed with polish. Attacks wherever it contacts the trailer. Both reasons why I only used it once. Used a car...
  6. L

    I/O (Sterndrive) Conversion to Outboards

    How long do the new engines need to be run-in for before you can get it on the plane / try full power?
  7. L

    I/O (Sterndrive) Conversion to Outboards

    Been following this thread a long time, looking forward to seeing pics of it on the water and hopefully reading how happy you are with it @tpenfield . Best of luck!
  8. L

    Can I buy a used 302 and use parts from my bad motor to convert it to marine?

    Question for @louc and @Scott Danforth If an engine / drive combination was available with either a Chevy or Ford motor, is it just the bellhousing that needs to be changed if swapping between the different motors or would you need to change the coupler and transom stuff too?
  9. L

    Help! Bought a 1993 Four Winns W/ 5.0 OMC Cobra Motor and Drive - Losing power after crusing

    If the engine cooling system presssure test crept down over 5 or 10 minutes I'd be doing it again and making sure there were no leaks at the plug... Creaping down is exactly what would happen if there were a small leak. Yes I would also be testing the manifolds. The worst thing that could...
  10. L

    Help! Bought a 1993 Four Winns W/ 5.0 OMC Cobra Motor and Drive - Losing power after crusing

    So the engine coolant circuit is holding pressure? The other way water can get into oil is if the exhausts are leaking water into the engine via exhaust ports. If there's such as a problem the water can get past piston rings into oil but the water can also cause hydraulic lock of the engine...
  11. L

    Can I buy a used 302 and use parts from my bad motor to convert it to marine?

    Yes you can. Probably a different cam, water pump, headgaskets, distributor, oil pan, etc but you can use parts from your engine. I might've done the same instead of rebuilding my boat engine but I'm in the UK and used 302 Windsor engines are not as available over here so I rebuilt mine. If I...
  12. L

    Help! Bought a 1993 Four Winns W/ 5.0 OMC Cobra Motor and Drive - Losing power after crusing

    That's not what I meant, I meant something like a hall effect sensor to detect engine rpm (crank sensor) and a similar hall effect sensor to detect drive rpm. I vey much doubt there'll be a speed sensor in the drive though.
  13. L

    Help! Bought a 1993 Four Winns W/ 5.0 OMC Cobra Motor and Drive - Losing power after crusing

    Is there something (electronic) that monitors engine revs versus drive speed and backs of power when they don't agree? I doubt it but I don't know if the dog clutch drives and EFI engine combination features it. That kind of thing is fitted on modern vehicles to prevent damage to...
  14. L

    Help! Bought a 1993 Four Winns W/ 5.0 OMC Cobra Motor and Drive - Losing power after crusing

    If it was the coupler wouldn't the actual engine revs climb while boat speed dropped off? In the video the tach shows the revs climbing but listening to the engine the actual revs drop. If the actual revs drop the boat speed will drop off but there's a difference between speed dropping because...
  15. L

    Help! Bought a 1993 Four Winns W/ 5.0 OMC Cobra Motor and Drive - Losing power after crusing

    If it's EFI will it have a crank position sensor that could be defective? I don't know how the rpm tachnometer at the helm (on the dashboard) connects to the EFI setup but regardless of if it gets it's signal from the ECU or from the coil, if the ECU uses a crank sensor that isn't reading...
  16. L

    Artificial Intelligence

    I've noticed AI repeating stuff I've written too. I used it recently for a different subject, comparing how various ammo would perform at various ranges (drop, velocity and terminal power, etc). On one occassion it got the answer to a simple ftlbe calculation obviously wrong, I corrected it by...
  17. L

    NEW YORK KNICKS ARE THE WORLD CHAMPIONS!!!!!

    Heh, I'm not into watching sports, never watch it on TV or go to games. Did used to enjoy playing a few sports such as soccer and rugby (the game American football originated from), not so much rounders (the girls game baseball originated from), not so much cricket (boring). At highschool we...
  18. L

    MS Office alternative

    I've got an old Toughbook too but the main reason I have that is because it runs XP and has the old (native) legacy serial and parallel ports on it which I need for some old software and ECU's. Heh it's battery lasts about 10 minutes so I need to keep it plugged in while using it but I only need...
  19. L

    MS Office alternative

    I have run Office 2013 (mostly Word and Excel but had the full package) on W11, it worked but occassionally doing certain things (iIrc scrolling) the screen flashed. I've got a pile of dead laptops, they tend to last a couple of years because I treat them a bit harshly doing diagnostics and...
  20. L

    I/O (Sterndrive) Conversion to Outboards

    Been re-reading the early parts of this thread because I'd forgotten some of the reasoning for converting from inboards to outboards. Sorry for going off subject a bit now, couldn't resist saying my grandad was on HMS Prince Of Wales when Hood was destroyed so saw it happen, one of his friends...
Top