Search results

  1. H

    Cork gasket

    When redoing a 2 line tank, does the cork need a dressing on it?
  2. H

    5.5 horse

    Thanks
  3. H

    5.5 horse

    Is 3.82 ohms an acceptable reading on a coil?
  4. H

    1953-54 25 horse evinrude

    Thanks fellas!!!!!
  5. H

    1953-54 25 horse evinrude

    It works , so I'll just leave it. Just kinda weird.
  6. H

    1953-54 25 horse evinrude

    This is the underside of the pull start. The actuator thingys aren't equally spaced. Took me awhile to figure this out. second pic is the top of it, it hooks to the carb and when in the down position, locks it from being pulled. What is it for? Can i disable it?
  7. H

    1953 fast twin (15012)

    Didn't know it had a fiber washer. Wouldn't have a picture of one, would you?
  8. H

    1953 fast twin (15012)

    Last problem I'm encountering is leaking around high speed adjustment and when i tighten the keeper, i can't turn the knob. Is there a tape or putty that's supposed to be there? Also, look at the pull cord on the other one, although it's a 25 horse. Copper covered in fabric.
  9. H

    Gas lines

    Went to NAPA got some, on second pull the old geezer fired right up.
  10. H

    Gas lines

    Its a 1957 7.5 horse, i was going to buy some bulk on amazon, but ill just go to NAPA down the street
  11. H

    Gas lines

    Under the hood. Anyone know the size to use?
  12. H

    Cowling gaskets for evinrude

    Can't get ahold of him on ebay
  13. H

    1953 15 horse

    Ok, cool. Thanks
  14. H

    Cowling gaskets for evinrude

    Any got a source for getting these? Also vintage decals, someone gave me a source for that and i can't find it anywhere.
  15. H

    1953 15 horse

    Both those pics show a key way slot in them, mine doesn't have that.
  16. H

    1953 15 horse

    My location is near Milwaukee
  17. H

    1953 15 horse

    Would you think it's the same part number through all those years ?
  18. H

    1953 15 horse

    Almost started, then i could barely pull the rope. Turns out the woodruff key sheared off. Took it apart an as i put it back together, i broke the armature plate mounting ring. Anyone use a good source to get parts for the old guy? Marine engine says the part number is 580168, but it keeps...
  19. H

    Bayliner Trophy Bilge pump question

    You should actually have 2 pumps, i have a 21 foot and have 3 on the suggestion of the coast gaurd when i had a vessel check.
  20. H

    Evinrude outboard year

    It's not at my house right now, the guy overspayed the tag, I'll try tomorrow. Thanks fellas!
Top