Search results

  1. S

    Concerns with exhaust

    I'll have to look this up. I didn't know this was an option .
  2. S

    Concerns with exhaust

    Thanks for the info. I used OEM impeller and the old one looked good to me which is why I'm concerned about the exhaust. But it was the 12 year old original. There was no obvious signs of overheating. The gauge was always mid range and never got too hot. Should I drain the block and manifold...
  3. S

    Concerns with exhaust

    Yeah probably. The boat has never sat in water, except when it's in use, so no longer than 12hrs. I inspected the bellows and the universal joint bellow is fine and looks good. No deformation, cracking or dry rot. I'm sure they need replaced. My main concern is doing the work to replace the...
  4. S

    Concerns with exhaust

    I replaced the carrier assembly seal, impeller, water tube and seals. I only discovered the shutter since it was stuck in the lower when I was replacing the carrier assembly seal. Since it was stuck it deformed the tube. When I looked at the rubber on the exhaust it was fine but exhaust bellow...
  5. S

    Concerns with exhaust

    Alpha 1 gen 2, 3.0 tks. Recently I had an exhaust shutter fall apart due to heat which caused a few issues in the stern drive. I have since fixed the stern drive and replaced the shutter. The exhaust bellow looks a little rough too. The boat is 12 years old and this is the first time I had this...
  6. S

    3.0 Mercruiser

    Just a thought. Can you remove the gas cap when it has trouble running and see if that works? Maybe it's a venting issue and opening the gas cap would allow the tank to vent and the carb to suck in more fuel.
  7. S

    Need help identify part

    Got it out finally. Was wedged in there real good and could barely see it. What a pain lol.
  8. S

    Need help identify part

    Hello everyone. Well I got the drive resealed and the exhaust shutter removed and about to install the new one but the old one only had the metal bar left and I only found one side of the shutter in the drive. I used a flashlight and long tool to see if it was in the exhaust somewhere buy I...
  9. S

    Need help identify part

    Thank you everyone for all the info. Well I completed the water pump and oil seal carrier tonight but cannot but the lower and upper back together until I get the water pick up tube replaced. Now to research the shutter replacement. Thanks again everyone.
  10. S

    Need help identify part

    No overheating problem at all. Everything was working fine until I decided to run it up after siting for awhile and noticed the gear oil coming out. The history on the boat is I have owned it since day 1 in 2011. It got used a fair amount over the years up until these last few years when it...
  11. S

    Need help identify part

    First time posting but have been reading alot on my Alpha 1 Gen 2 sterndrive, 98+ version. I have gear oil leaking out the water intake and have decided to replace the carrier seal below the impeller. When I got the lower separated from the upper a piece of black rubber fell out. Pics attached...
Top