Search results

  1. N

    1995 Johnson 115 OceanRunner trim motor (video)

    should the sending unit for the trim gauge be in a certain position? I can't tell if it's off the spring or if it's OK
  2. N

    1995 Johnson 115 OceanRunner trim motor (video)

    OK so I went out there again (after pumping in new hydraulic fluid earlier in the day) and really tightened the manual release screw and it was able to go up. It struggled going down, but if I loosened the manual screw a bit and it seemed to knock it loose and it went up and down. Bled the air...
  3. N

    1995 Johnson 115 OceanRunner trim motor (video)

    It was, but I tried loosening it to see if that might help. Should it be as tight as possible? And yes, seals seem fine
  4. N

    1995 Johnson 115 OceanRunner trim motor (video)

    Hi all, a little while back I was keeping my boat on the water (Savannah, GA) and my battery died and the boat took on a lot of water near the rear. I had to get a tow-out and once we made it to the boat ramp, I had to manually release the trim to raise the motor to get it on the trailer. Since...
Top