Search results

  1. T

    battery losing water

    my water level drops a lot in my starter battery but not in my trolling batteries while stored. it is hot in stge unit. no leaks found, could lids not fit tight enough and evaportation takes place. any suggestions on sealing. no elec. wires hooked to batteries while stored. Puzzled.
  2. T

    battery losing water

    my water level drops a lot in my starter battery but not in my trolling batteries while stored. it is hot in stge unit. no leaks found, could lids not fit tight enough and evaportation takes place. any suggestions on sealing. no elec. wires hooked to batteries while stored. Puzzled.
  3. T

    rectifier for 125 force. yr 87 can I install & part number?

    Can I replace this with out any special tools? where,how and what does it look like?
  4. T

    new impeller installed- water output question

    I installed the new impeller, 120 force yr87, in idle the discharge of water from engine looks good, at full throttle it appears the discharge just pours out or gulps out, I thought it should be more forceful (a jet stream). Would the thermostat have anything to do with this part of the water...
  5. T

    storage maintenance chargers????

    I bought those slow charges for leaving the boat in storage charging all the time. It did not charge my battery after a weeks time, is that normal? Also can a nonfunctioning rmp gauge run down a battery, it just stopped working one time and not sure if it could be drawing a current. advise...
  6. T

    125 hp force-remounting drive shaft to engine

    I replaced the water pump and have done this twice before but this time unable to install the driver shaft into the upper engine splines any easy suggestions for quick installation, unable to line it up for some reason.
  7. T

    easy release of tilt and trim ???

    I am trying to pull boat out of water, elec goes out and motor in down position. motor has a longer fin on bottom underneath propeller. it will drag and rip everything. How do we release tilt and trim to manually lift motor?? 125 hp force. 1987
  8. T

    replacing impeller on 125 force

    125 force 1987 , do I lubricate the housing once I replace with new impeller and do I regrease the splines on the drive shaft before reinstalling. Or anything else I should do. I need the impeller and gaskets but am finding it hard to locate even on this website they only had thermostat. Does...
Top