Search results

  1. S

    hydraulic lines leaking on 115 horse mariner trim

    I have a 115 horse mariner. the power trim lines were replaced with brand new ones but now leak. I put teflon tape on all of them and they are still leaking. Any suggestions
  2. S

    115 mariner leaking gas

    Hey guys! I have a 115 horse Mercury Mariner that leaks gas when the motor is tilted to the up position anybody have any idea what the problem is? Maybe need a carb rebuild??? If anybody can help I appreciate it thanks
  3. S

    135 horse owners manual

    Anybody know where i can find repair information on a 135 mercury mariner with out spending $$$$$ for the book. Thank You
  4. S

    High idle at start on 135 mariner 1996

    Just bought a 1996 135 horse mercury mariner . runs but starts rough and once started the thing goes full blast to the point of spinning bearings or blowing up all together. Is this a throttle adjustment or something else and if it is throttle adjustment can somebody PLEASE! Help me find where...
  5. S

    To big of a prop?????????

    I have a 90 horse evinrude on a 19 foot glasply impulse. Motor runs great. compression is good in all cylinders carbs rebuilt new wires plgs and fuel line. she runs great but takes a few minutes to get up to full speed and then only 3800 rpms. Is it to big of prop it has a 17 on it or is it...
  6. S

    evinrude slow moving

    I have a 90 horse evinrude on a 19 foot glasply impulse. Motor runs great. compression is good in all cylinders carbs rebuilt new wires plgs and fuel line. she runs great but takes a few minutes to get up to full speed and then only 3800 rpms. Is it to big of prop it has a 17 on it or is it...
  7. S

    90 horse eveinrude fuel filter part number

    I have a 1985 90 horse evinrude on a 17 foot glasply impulse. She does fine after pulling out of the hole but very sluggish getting out and while full throttle. I think it might be the fuel filter. Any other ideas or can somebody give me the part number for the fuel filter and I will start...
  8. S

    Water in cylinders

    I have a 1985 90h evinrude on a 19 ft impulse and the dealer is telling me there is a bad seal some where on this thing and water is geting into my cylinders what kind of seal would this be and is it detrimental to the future life of this engine
  9. S

    90 horse evinrude on 19 footer

    compression is good. they installed a new OMC ignition system on this thing and I was wondering since the gauges dont work would this have anything to do with the motor geting no horse power like a throttle cable problem
  10. S

    My first boat

    I just bought a 1985 19 ft glasply impulse with a 90 horse evinrude on it this thing does not even take the boat 10 miles an hour the dealer says it should move around 38 to 40 he rebuilt the carbs and replaced the prop to no avail is this a throttle cable problem or just not a enough horsepower...
Top