Search results

  1. B

    JB Weld for Exhaust manifold?

    A friend of mine has a V8 engine in his boat (I'm not sure what kind) and asked me if there is a product that could seal a small maifold leak. Can JB weld to the job or is there an alternative (other than replacing the manifold)?
  2. B

    Gear lubrication needed?

    I have a 1979 19' Reinell with a 120hp GM 4 cylinder and a stringer outdrive. I don't know too much about outdrives, but thanks to this site I'm learning more everyday. My question is this: There is a gear set that connects the engine drive shaft to the upper unit. When the outdrive it up...
  3. B

    Cause for Hydrolock?

    First, a little back story: A month ago (in April) we purchased a 1976 19' Reinell cuddy with a 1990 GM 120hp 4 cylinder motor and the original (although rebuilt two years ago) OMC stringer outdrive. When we were out on the test ride, the engine started fine and seemed to run fine. The boat...
  4. B

    How much water pressure when running engine out of the water?

    Hello there, I've been browsing the forums for about six hours now and have not yet found an anwer to my question, so I decided to start a new thread. I have a 1976 Rienell with a 1990 120hp GM engine and the original (but rebuilt a year ago) OMC Stringer outdrive. It has a water flush...
  5. B

    Hydraulic Oil for Trim\Tilt

    I am repairing the trim/tilt for my 1985 90 hp Johnson, but I'm not sure what kind of hydraulic oil to use. Is there a special "marine grade" I should use, or will just regular ol' hydraulic oil work? Thanks in adavance... :)
  6. B

    Finding the VIN on an EZ Loader

    Hello fellow stink boaters! I have browsed this forum many times and found loads of valuable information but this is my first request for info. I just bought a used 16' Tiderunner with an EZ loader trailer, but when I went to get the title for the trailer transfered, the DOL said there were...
Top