Search results

  1. C

    moter stuck in forward gear

    1992 200 hp. yamaha.came in last nite and went to back into slip. when trying to shift into reverse, motor stayed in forward and now will not shift out of gear.shift cable moved shift shaft, but no results. i removed shift cable and shifted by hand. shift shaft moved ,but still stuck in forward...
  2. C

    switch LHR to RHR MOTOR

    i have a standard rotation gm350/515hp. with less than 30 hrs. it needs to be switched to right hand rotation for a penn yan that has right hand running gear. can this be done? has anyone done it? i know i have to change the cam, distributor, front and rear main seals,timing chain to...
  3. C

    350 indmar engine removal/cobra drive

    i need some answers on engine removal for an 87 bayliner cierra 2450. the motor is new ( under 50 hrs.), INDMAR MARINE coupled to an OMC COBRA DRIVE and i want to save it for when my 350 crusader goes in my 24ft.penn yan. i have removed the outdrive, unbolted the motor mounts and removed all...
  4. C

    penn yan prop size

    does anyone know the correct prop for a 1973 24 ft. penn yan tunnel drive with a 350 crusader motor,270 hp. 1 inch shaft. or where i can find manufactures info on this boat...... thanks
  5. C

    Garmin G-chart Wanted

    EDIT: Sorry, cmorri. No soliciting allowed here. Try eBay.
  6. C

    73 grady/inline 6 prop selection

    can anyone tell me what the correct prop or factory prop would be for a 73 grady white nassau running a mercruiser inline 6/250 /165 hp. motor would be.it came with a 14x16 prop which needs replacing. is this the right one? thanks.also is it possible to pull the motor( it is shot) without...
  7. C

    have serial # need year evinrude

    can anyone direct me to a site or help me find the year for the motor i have? i have the serial # and would like to purchase parts and repair manual...motor is 7.5 hp. ser.#E0177097 or E8RCTA EVINRUDE
  8. C

    counter rotating swap for reg.rotation omc stringer

    i just purchased a great running inline 6 250 mercruiser without knowing that it was counter rotating and now i have to keep it. can i swap this out with my blown standard rotation? i understand how to make it standard rotation, change cam,starter.timing gears,dist. gear etc. but can i just use...
  9. C

    omc repower questions

    i now have a 73 grady with a merc inline 6 mated to an omc stringer electric shift.can i put in a 4.3 V-6 ?will it bolt up and will the outdrive handle it? i assume i will have to modify the motor mounts. any other issues i need to be aware of? thanks
  10. C

    165 inline6 only gets 2000 rpm stringer drive

    hello, i have a 1973 grady with an inline 6 -165hp. 250 mercruiser being pushed by an omc stringer electric shift. i can only get 1800-2000 rpm when under load. at the dock she will rev.3500+.i have put on rebuilt carb,new fuel lines changed filters, new points,plugs ,wires,cap,rotor.i thought...
  11. C

    LOOKING FOR TILT CLUTCH DISK PLATES

    i have a 1973 omc stern drive with a straight 6 chevy, and cannot find the clutch pack plates for the tilt unit .i also need the oil seal that goes on the tilt gear housing...thanks
Top