Search results

  1. M

    300 HPDI 2004,wont shut down immediatly,also,does this mtr have the midsection issue?

    engine runs fine. Bought it about 3 years ago,and,will not shut down immediatly.Takes sometimes 15 seconds after switched off. Would appreciate any info. My gut says keyswitch.Also,does this engine year and H.P.have the midsection problem of corrosion. Thank You
  2. M

    1999 70 yamaha carb.

    Any ideas where i might get a used one,bottom carb,beyond rebuild.
  3. M

    2003 90 hp yamaha NO GEARS,NOT shaft

    Pulled lower unit off,have no response,no fwd or rev, while manually shifting and turning driveshaft,obvious to me problem is in the gearcase,BUT,anyone tell me what it likely is.Worked fine one minute,nothing next.Thanks
  4. M

    Compatable lower units

    I'm looking for a used lower unit for my 1994 150 25' shaft.Could anyone help me with the compatable yrs.Thanks
  5. M

    Been a while since I posted,Any old friends left.

    I blew my 1994 Yammy lower and gears are OK,but wondering if ANYONE had luck welding cracks from behind prop up to the end of the carrier.? It just cracked,I found oil leaking when hauled,LUCKY I know.But thinking Id like to weld,but lookin like I need replacement.Any ideas R appreciated.I...
  6. M

    Blew my 1994 150 lower

    Realy dont want to buy a NEW gearcase,anyone have any luck welding a crack from behind the prop ,and stopping before the carrier ends.Im in Fl Keys and used are not easily avail.1994 150 25 in.
  7. M

    Yamaha choke/primer ?

    1997 90 hp/Have had issues for a long time.What I think I found,the panel on boat has a choke switch as well as a key switch,Seperate switches.I found the blue choke/primer or what ever they call it wire, from the eng ,tied in to the yellow ,run circut.Well it was fried.But ,what I think I...
  8. M

    tachometer compatability

    need another tach for 97 90 hp yam. my current tach has squqre plugs ,a guy on ebay has a tach,looks same ,except for round plugs,.Can I use the round plug tach if I do necessary wiring work,or are the tachs ,different internally.
  9. M

    1999 225 vtec questions

    Seriously thinking of buying a 1999 25 ft.Seacraft ,it has 2 -225 honda vtecs,400 hrs total,boat sat unused for last 2 yrs.been an OMC guy mostly and know NOTHING of the newer fuel injected hondas.Engines look showroom,I expect fuel issues,NEED ADVICE how to proceed to get her running if I make...
  10. M

    1996 225 will not idle down

    Been suggested that something wrong in the warm up system.It was suggested if I ground the black/white sensor wire ,the sensor will tell the powerpack to idle down.It wont go below 1500 out of water.Other than that the eng is fine at all other speeds.My gut feeling is ,it must then be the...
  11. M

    guage replacement

    Looking to redo my console.I have a 1996 yamaha 90.Is it possible to change the multi guages ,which are totally trashed ,and put in a ,aftermarket tach and fuel ,oil guage?Im not interested in the speedo.Thanks
  12. M

    1995 200 power loss ,why?

    Compression is all 125 + - 5 .Carbs were done 2x with kits,spark tester shows spark on all cylinders,idles fine,high speed ,only getting 5100,bogs to plane,ive tried shooting mixed fuel into each cyl.with each cyl.bogging as flooded ,EXCEPT for the portside top,I have pulled the plugwire off and...
  13. M

    1996 90 yamaha choke/primer

    Seems the starter assy .as Yamaha calls it ,isnt working.I put pos.to the blue wire and neg to ground.No action.My guess is its a thro away part,nyone have any input as to whether it can be fixed? it definatly in the unit,I have testd the wires to point of entry
  14. M

    1996 90hp shift shaft

    Well ,my Yamaha is finally starting to ask for some new parts.Im usually over in the OMC side.Anyway,shift shaft went this week,I will also need a new trim n tilt motor,figure I may as well do it all while its apart.Oh,and the pivot tube has been bad.So,I intend to replace the pivot with a...
  15. M

    1996 225 idle trouble

    My turn for questions guys.My 96 226 johnson ,decided to give my grief today while of course docking.It stalled ,due to idle going too low.Then decided it should run at 2000 RPM.It was back and forth,hi to low rpm.Whats your first guesses. Thanks as always./Mike
  16. M

    Private messags/profile

    Anyone else having trouble sending private messages,or seeing profiles?
  17. M

    after market oil filters

    anyone know if there is an after market oil filter for yamaha four stroke 2004 225hp
  18. M

    MY TURN for? 1996 225,idle prob

    Hey guys,my boat sat up for a while.took for a run and when returning to the dock it idled high,I thought the cable but shut down then restarted and idled o.Any ides.AND,my TNT unit has been acting up since i got the eng 2 yrs ago.if I let it sit,it will act as though it has no oil.Its not...
  19. M

    BRP website trouble

    Been trying to look up parts on BRP ,as I go thru menu ,once I get to actual parts ,it changes back to choose the yr.Any info about it,
  20. M

    1996 115 merc.info

    thinking about a bout with a 1996 115 four cylinder merc.is this motor a force with merc decals,I know some mercs were forces that transitioned after merc took over force,also,I didnt see the boat yet,will the motor ikely have trim and tilt.thanks
Top