Search results

  1. K

    Overheat Buzzer stay on!

    Hi all! My Father-n-law has a 1993 Mariner 135. He turned the ignition key on yesterday and the alarm buzzer in the console went off. The motor started and the alarm continued a solid horn. I think I remember that the solid chirp is heat and the intermitant chirp is oil level. I told him by...
  2. K

    1993 Mariner 135 tilt/trim question(follow up)

    My paw-in-law has a 1993 mariner 135. He had a new tilt motor installed several weeks ago. The tilt has not held since. When you tilt it up it slowly goes back to the full down position. There has been ample time to bleed out the air in the system so now I think there is trash in the check...
  3. K

    1993 Mariner 135 tilt/trim question

    I have a 1993 Mariner 135. A new trim motor was installed and the Mechanic did not fill the hydraulic fluid. What is the correct way to fill this unit? The lower "fill" screw that is accessed through a hole on the right motor mount bracket is too deep to get the cone on the Hydraulic oil tube to...
  4. K

    1993 Mariner 135 tilt/trim...can't keep it up

    I have a 1993 Mariner 135. A new trim motor was installed and the Mechanic did not fill the hydraulic fluid. What is the correct way to fill this unit? The lower "fill" screw that is accessed through a hole on the right motor mount bracket is too deep to get the cone on the Hydraulic oil tube to...
  5. K

    1993 Mariner Trim motor Hydraulic oil fill....

    Hey all, I am trying to get the right procedure for filling the trim motor with hydraulic oil. Should you take out the upper screw/knob and inject the fluid into the lower "release" screw until the fluid runs out of the opper screw, then tighten the upper to create vacuum and then tighten the...
  6. K

    Where is the tilt/trim hydraulic fill spout on a 1993 Mariner 135

    I have had a lot of advice on the fill procedure but it is not obvious on the trim unit where to actually pour in the fluid. I can not find any obvious filler cap on it. Do you inject it in the drain screw like you would lower unit oil...
  7. K

    Filling the tilt hydraulics?

    Hi all! I have a 1993 135 mariner and I need to add hydraulic fluid after the new tilt motor was replaced. We had released the lower drain screw in order to manually tilt the motor at the launch when the old tilit motor burned up. Where exactly do I add the fluid and what is the proper...
Top