1956 3hp sea king motor prop

[sbf000]

i am looking for parts for my 1956 3hp sea king, namely the prop and water pump and a seal that goes on the primer plunger??? does anyone know where i can get these parts or know if a different brand of prop will fit my motor?

 

[steelespike]

Re: 1956 3hp sea king motor prop

This is the Prop forum; you'll likely do better in the other outboard forum.
There is no seal on the primer plunger that is the float needle and it needs to move freely.
Water pump "rotor" should be available from someone at www.aomci.org No doubt someone can help with a prop as well.Fuel mix is 24:1 use tcw3 rated oil.point gap .020 plug gap .030.Modern lube for the gearcase is lubriplate 105. Gas tank .5 gal. wot run time approx.1 1/2 hours.