1975 9.9 Johnson outboard

rhendershot

Cadet
Joined
Apr 5, 2011
Messages
9
I want to offer a guy a fair price for this motor. We got it to run after several attempts. Its not ran for 2 years. I brought fresh gas and we got it going. Anyone have any ideas? Thanks
 

Daviet

Fleet Admiral
Joined
Sep 24, 2008
Messages
8,958
Re: 1975 9.9 Johnson outboard

It's his engine, have him tell you what he wants for it.
 

rhendershot

Cadet
Joined
Apr 5, 2011
Messages
9
Re: 1975 9.9 Johnson outboard

He said he wanted 500 for it. My concern is the time it sat (2 years) and was not ran. My concern is dried diaphragms, Impeller and Gear oil. Things like that.
 

Rick.

Captain
Joined
Jul 30, 2006
Messages
3,740
Re: 1975 9.9 Johnson outboard

I wouldn't be too concerned about it sitting for two years. I would be more concerned that it is an older motor and likely to have some age related issues that should be looked at as a preventative maintenance routine. To reduce the risk of unexpected breakdowns I would consider doing the following work even if fresh gas got it running. Carb. kit, water pump kit, coils, points, condensers, plugs, wires, gear oil change, linc & sync., installing a tell tale and probably a few other things I can't think of right now. I'm not pointing this all out to scare you off, just so you know your going to need to spend some time and money on it over and above the "asking price". Perhaps your comfortable not doing the maintenance I mentioned but I would not be and would have to consider the additional expense added to his price. No matter what, do a compression check and check the gear oil and for spark in both cylinders before you buy it. 9.9's are great motors in general and seem to run for a long long time. Best of luck. Rick.
 

OptsyEagle

Lieutenant
Joined
Sep 13, 2006
Messages
1,365
Re: 1975 9.9 Johnson outboard

Where I live, that is about what they go for. They are a good motor, will run for years, but as Rick said and like all other motors a little maintenance is required and will be ongoing.

If you can check the spark and get it to jump a 3/8" gap, I would probably not replace any coils, points, condensers or wire unless another problem came up that forces you to do so. It wouldn't hurt to re-set the points gap but if it runs well and you have never done that before, I would waive that as well.

I wouldn't install a new tell tale since, I personally have no problem viewing the water from the exhaust port, as per that model's design, so I do not know why people go to this trouble. Even the carb kit. If it starts, runs and most importantly idles well, I would leave that as well.

The impeller needs to be changed, even if it pumps water well, unless you know how old it is and it is less then 5 years old. Impellers need to be changed when they are working well, since the alternative is to wait to change them after they fail. That plan only gives you, at most, a 60 second window, so change the impeller, its a $15 part and a 1 hour job.

The gear oil also needs to be changed every season if left below freezing temperatures in the winter and fairly regularly, even if stored in your basement. Look to see if water is getting in. The oil will be a milky consistency and if the motor has sat for more then a week, the water should be at the bottom of the mix and come out first when you open the drain screw. If no water, yell "yeah baby", and re-fill it with gear oil.
 
Top