Have had boat 16 months, Tilt Trim did not work<br />at all.Found brushes siezed in holders.Replaced<br />brush and springs,It worked good for about 1 month.<br />When it was working, motor would lift and lower<br />and not leakdown. The inside of the trim elec. motor was badly corroided. My question is, when I turn the thumb wheel on the trim assy. to manually<br />raise and lower the outboard I am unable to lift the motor from the down position.I have found a replacement trimmotor/resivor assy for about 210.00. But I here the trim pump assy. is not available. Any suggestions on evaluating the <br />hydrolic part of the system before the investment<br />of the elec. motor? Is it poss to remove the armature of the motor and use a drill motor to<br />spin the pump? Also a couple of the fluid lines<br />at the pump unit appear to be leaking a bit. Is<br />this normally corrected by o-rings or is it a bigger problem? Thanks
