1985 40 hp Evinrude keeps cranking won't idle

Turtlelips

Seaman Apprentice
Joined
May 14, 2004
Messages
46
I have a 1985 40 hp Evinrude. I prime the bulb raise the idle to start position but my motor just cranks and cranks. After a while of cranking it fires and runs. Smoke comes out and burns but when I turn the motor off after it is warmed up it takes a while for it to restart again. I also have another question. The motor does not like idle at low rpms. Any ideas of what might be the cause of these problems?<br /><br />Thanks in advance
 

Reel Appeal

Chief Petty Officer
Joined
Aug 19, 2002
Messages
566
Re: 1985 40 hp Evinrude keeps cranking won't idle

You mentioned nothing about using the choke so I must ask....Is there a toggle choke switch under the key? Do you choke it when turning over?If there is, lift up on this switch(when cold)while using the key to start.
 

Turtlelips

Seaman Apprentice
Joined
May 14, 2004
Messages
46
Re: 1985 40 hp Evinrude keeps cranking won't idle

I have an electric primer solenoid that is activated when I push the key in while I am starting the motor. I am also not sure of which way the little red lever on the solenoid is suppose to be facing.
 
Top