Hey guys,
Have a few questions:
1. What to use on tubes for cleaning and polishing. How to to do a good job that is last.
2. I saw one little hole not even an eighth of an inch in the front of one of the tubes. What can i patch it with so that I get it on the lake and run it before it gets to cold? Will get it welded up this winter and have them presure tested.
3. The boat set up for 2 years, I had the guy start it and put into gear. F/R.
Ran and shifted fine. Motor looks super clean under cover.
What should I do and look for before I take it to the lake. Will it be okay to put the muffs back on and let it run for some time before I go.
4. Where can I get some parts for the boat. 1. Fuse panel cover. 2. Manuals for boat and motor.
Thanks, like what I been reading here and decided this would be a good place to start.
Have a few questions:
1. What to use on tubes for cleaning and polishing. How to to do a good job that is last.
2. I saw one little hole not even an eighth of an inch in the front of one of the tubes. What can i patch it with so that I get it on the lake and run it before it gets to cold? Will get it welded up this winter and have them presure tested.
3. The boat set up for 2 years, I had the guy start it and put into gear. F/R.
Ran and shifted fine. Motor looks super clean under cover.
What should I do and look for before I take it to the lake. Will it be okay to put the muffs back on and let it run for some time before I go.
4. Where can I get some parts for the boat. 1. Fuse panel cover. 2. Manuals for boat and motor.
Thanks, like what I been reading here and decided this would be a good place to start.